Page 2 - CE Mark Warning
The Atlantis Land logo is a registered trademark of Atlants Land SpA. All other names mentioned mat be trademarks or registered trademarks of their respective owners. Subject to change without notice. No liability for technical errors and/or omissions. FCC Warning This equipment has been tested and ...
Page 3 - LED; CONNECTING THE SWITCH
i T A B L E O F C O N T E N T S ABOUT THIS GUIDE ................................................... II T ERMS /U SAGE ................................................................. II INTRODUCTION ........................................................... 1 F AST E THERNET T ECHNOLOGY ............
Page 4 - ii; B O U T; Congratulations on your purchase of the; plus; In this guide, the term “; Switch; ” (first letter upper case) refers to your; switch; refers to other Ethernet switches.
ii A B O U T T H I S G U I D E Congratulations on your purchase of the Management/Smart Gigabit & Fast Ethernet Switch (2×1000BASE plus 24×10/100BASE ports) . In this guide, you will find about the following four models: 1. 2×1000BASE-T plus 24×10/100BASE-TX Gigabit Switch 2. 2×1000BASE-SX plus ...
Page 5 - N T R O D U C T I O N; Fast Ethernet Technology
1 I N T R O D U C T I O N This chapter describes the features of the Switch and some background information about Ethernet/Fast Ethernet/Gigabit Ethernet switching technology. Fast Ethernet Technology The growing importance of LANs and the increasing complexity of desktop computing applications are ...
Page 7 - Switching Technology; segments
3 Switching Technology Another approach to pushing beyond the limits of Ethernet technology is the development of switching technology. A switch bridges Ethernet packets at the MAC address level of the Ethernet protocol transmitting among connected Ethernet or Fast Ethernet LAN segments. Switching i...
Page 8 - Features
4 Features 24×10/100Mbps Auto-negotiation Ethernet ports and 2×10/100/1000Mbps Auto-negotiation Copper Gigabit Ethernet ports or 2×1000BASE-SX Fiber Gigabit Ethernet ports Auto MDI-X for all TX ports Full/half duplex transfer mode for each port Wire speed reception and transmission Store-and-Forward...
Page 9 - Unpacking
5 U N PA C K I N G A N D I N S TA L L AT I O N This chapter provides unpacking and installation information for the Switch. To avoid causing any damage to the Switch, we recommend that you read this chapter carefully before starting installation. Unpacking Open the shipping carton of the Switch and ...
Page 10 - Installation
6 Installation The site where you place the Switch may greatly affect its performance. When installing, take the following into your consideration: Install the Switch in a site free from strong electromagnetic field generators (such as motors), vibration, dust, and direct exposure to sunlight. Leave...
Page 11 - Rack Mounting
7 Rack Mounting The Switch can be mounted in an EIA standard-size, 19-inch rack, which can be placed in a wiring closet with other equipments. Attach the mounting brackets to both sides of the Switch (one at each side), and secure them with the provided screws. Then, use screws provided with the equ...
Page 12 - Front Panel; Refer to the next chapter; ORT
9 I D E N T I F Y I N G E X T E R N A L C O M P O N E N T S This chapter identifies all the major external components of the Switch. Both the front and rear panels are shown below, with a description of each panel features. Front Panel FAN FA ULT P OWE R CONS OLE MG M 2 ×1000BASE-T plus 24×10/100BAS...
Page 13 - - The Switch is equipped with two Gigabit fiber-optic ports, the SC; ONSOLE; Attach a; Rear Panel
10 P ORT 25 & P ORT 26 1000BASE-T Twisted Pair Ports (RJ-45) or 1000BASE-SX Fiber-Optic Ports (SC) - These two RJ-45 ports are auto MDI-X ports: The Switch is equipped with two Gigabit twisted pair ports, the ports will auto negotiate 10/100/1000Mbps. - The Switch is equipped with two Gigabit fi...
Page 14 - N D E R S TA N D I N G; L E D I; N D I C AT O R S
11 U N D E R S TA N D I N G L E D I N D I C AT O R S The front panel LEDs provide instant status feedback, and, helps monitor and troubleshoot when needed. PWR Power Indicator (green) On : When the green light is on, the Switch is receiving power. Off : Power cut off or improper connection. FAN FAUL...
Page 15 - Ports 1~24 Status LEDs
12 FAN FAULT P OW E R CONSOL E MGM Ports 1~24 Status LEDs LINK/ACT Link/Activity (green; amber) On (Green) : When the green light is on, the respective port is connected to a 100Mbps Fast Ethernet network. Blinking (Green) : When the green light is blinking, the port is transmitting or receiving dat...
Page 16 - Port 25 & Port 26 Status LEDs
13 Port 25 & Port 26 Status LEDs 1000BASE-T 1000M LINK/ACT Link/Activity (green) On : When the green light is on, the respective port is connected to a Gigabit Ethernet network. Blinking : When the green light is blinking, the port is transmitting or receiving data on the 1000Mbps network. Off :...
Page 19 - Cable Specification; Speed Connector
16 Cable Specification Speed Connector Port Speed Half/Full Duplex Cable Max. Distance 10BASE-T RJ-45 10/20 Mbps 2-pair UTP/STP Cat. 3, 4, 5 100 m 100BASE-TX RJ-45 100/200 Mbps 2-pair UTP/STP Cat. 5 100 m 1000BASE-T RJ-45 1000/2000 Mbps 4-pair UTP/STP Cat. 5 (Cat. 5E is recommended) 100 m SC 1000/20...
Page 20 - Port Speed & Duplex Mode
17 C O N F I G U R I N G T H E S W I T C H This chapter explains how to configure the Switch to enable its smart functions. Port Speed & Duplex Mode By default, the Switch determines the transmission mode by auto-negotiation for any new twisted-pair or fiber connection after attaching the proper...
Page 21 - Console port settings; Product Support; or
18 Baud rate of 9600bps No parity 8 data bits 1 stop bit Console port settings Flow Control: None The Management/Smart function setting user’s guide is in the attached Diskette. Product Support If you continue to have problems you should contact the dealer where you bought this product. If you have ...
Page 22 - General
19 T E C H N I C A L S P E C I F I C AT I O N S General Standards IEEE 802.3 10BASE-T Ethernet IEEE 802.3u 100 BASE-TX Fast Ethernet IEEE 802.3ab 1000BASE-T Gigabit Ethernet IEEE 802.3z 1000BASE-SX Gigabit Ethernet Protocol CSMA/CD Data Transfer Rate Ethernet: 10Mbps (half duplex), 20Mbps (full dupl...
Page 23 - Physical and Environmental; Performance
20 Physical and Environmental AC inputs: 100 to 240 VAC, 50 or 60 Hz internal universal power supply Power Consumption: 25 watts. (max.) Temperature Operating: 0 ° ~ 50 ° C, Storage: -10 ° ~ 70 ° C Humidity Operating: 10% ~ 90%, Storage: 5% ~ 90% Dimensions: 440 x 200 x 44 mm (W x H x D) Weight: 2.8...
