AprilAire 70 - Manual

AprilAire 70

AprilAire 70 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
Page: / 4

Table of Contents:

  • Page 2 – STEP 1. CHOOSE A LOCATION TO MOUNT THE CONTROL; MOUNT CONTROL...; Figure 1 – Disassemble the Control; LIVING SPACE CONTROL INSTALLATION INSTRUCTIONS; STEP 2. DISASSEMBLE THE CONTROL; SPECIFICATIONS
  • Page 3 – Figure 2; Route wires through square hole in; Figure 2 – Mount the Control; STEP 3. MOUNT THE CONTROL ON THE WALL; Secure the wires to the backing plate and main control; Figure 3; wiring; STEP 4. WIRE THE CONTROL; Figure 3 – Wire the Control
  • Page 4 – elapsed for system initialization.; STEP 5. REASSEMBLE THE CONTROL; Figure 4 – Integrated Sensor Control Board
Loading the manual

Model 70 Living Space Control

Installation Manual

For use with Aprilaire

®

Central Dehumidifier

Models 1700, 1720, 1710, 1750, 1770, 1710A, 1750A, 1770A

Living Space Control

WARNING

120 volts may cause serious injury from electrical shock. Disconnect electrical power to
the furnace & air conditioner before starting installation. This Living Space Control is not
a 120 volt (line voltage) device.
Improper installation may cause serious injury from electrical shock. This product must
be installed by a qualified heating & air conditioning contractor in accordance with NEC
Standards and applicable local and state codes.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - STEP 1. CHOOSE A LOCATION TO MOUNT THE CONTROL; MOUNT CONTROL...; Figure 1 – Disassemble the Control; LIVING SPACE CONTROL INSTALLATION INSTRUCTIONS; STEP 2. DISASSEMBLE THE CONTROL; SPECIFICATIONS

STEP 1. CHOOSE A LOCATION TO MOUNT THE CONTROL The Model 70 Living Space Control contains its own sensors that override the Aprilaire CentralDehumidifier main control sensors when connected and enabled. Therefore, the control should belocated in an area (living room, master bedroom, etc.) where the ...

Page 3 - Figure 2; Route wires through square hole in; Figure 2 – Mount the Control; STEP 3. MOUNT THE CONTROL ON THE WALL; Secure the wires to the backing plate and main control; Figure 3; wiring; STEP 4. WIRE THE CONTROL; Figure 3 – Wire the Control

There are two mounting screws and two drywall anchors provided with the control. See Figure 2 . 1. Route wires through square hole in backing plate. Level backing plateagainst wall and mark two of themounting holes. 2. Drill two 3/16” diameter holes at the marked locations and install drywallanchors...

Page 4 - elapsed for system initialization.; STEP 5. REASSEMBLE THE CONTROL; Figure 4 – Integrated Sensor Control Board

SYSTEM SETUP ON OFF MODEL 70 MODEL 70 REMOVABLE SENSOR BOARD 10006367 8.09 B2203506D No tools required – snap the front cover back on the backing plate, being careful to align the 6-pinterminal block on the cover with the receptacle on the backing plate. 1. Turn the HVAC equipment back on to normal ...

Other AprilAire Models