AprilAire 65 - Manual
AprilAire 65 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – The Aprilaire; ElECTRICAl; SPECIfICATIONS; CONTROl; lOCATION RECOMMENDATIONS; • In an area the homeowner wants to; MATERIAlS PROVIDED
- Page 3 – INSTAllATION; MOUNT CONTROl; fIGURE 2 – Disassemble Control; See; WIRING; receptacle on the back plate.; SySTEM CHECKOUT
- Page 5 – POWER UP; blinking ON; Humidifier with Model 850 fan Pack
- Page 6 – TROUblESHOOTING
- Page 7 – TAblE 1 – Troubleshooting Guide; • Verify that the humidifier is wired correctly.
Model 65 Humidifier Control
Installation Instructions
R E A D A N D S AV E T H E S E I N S T R U C T I O N S
CAUTION
1. Read all instructions before beginning installation.
2. Do not adjust humidity set-point above recommended level or to recommended
level if condensation occurs on inside surface of windows or on other surfaces.
Excess condensation can cause damage to structure or furnishings. Excess
moisture can also allow the possibility for mold growth to occur.
3. Do not use solvents or cleaners on or near the display and circuit board.
Chemicals can damage components.
WARNING
1. Improper installation may cause property damage or injury. Installation, service,
and maintenance must be performed by a qualified service technician.
2. 120 Volts may cause serious injury from electric shock. Disconnect electrical
power before starting installation or servicing. Leave power disconnected until
installation/service is completed. This control is not a 120 Volt (line voltage)
device.
SAfETy INSTRUCTIONS
The Model 65 is for use with any humidifier
requiring an ON/Off signal for a 24 volt circuit.
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TAblE Of CONTENTS Safety Instructions . . . . . . . . . . . . . . . . . . 1 Overview . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Specifications . . . . . . . . . . . . . . . . . . . . . . 2 Materials Provided . . . . . . . . . . . . . . . . . 3 location Recommendations . . . . . . . . . 3 ...
INSTAllATION MOUNT CONTROl PULL AP ART FRONT COVER BACK PLATE RH SETTING LABEL H H R C fIGURE 2 – Disassemble Control 90-1667 H H R C BACK PLATE ANCHOR SCREW MOUNTING HOLES WIRE ACCESS OPENING 4-CONDUCTOR WIRE fIGURE 3 – Mount back Plate 90- 1668 See figures 2 & 3 . 1 . Remove front cover by pul...
SySTEM CHECKOUT POWER UP 1. Check all wiring. 2 . Restore power to the HVAC system and humidifier .3 . After a 4 second start up sequence all buttons on the Model 65 will be functional . • The control will be OFF. • The humidity setting will be 30%. • The control will display the measured humidity. ...