APC BE350G - Manual

APC BE350G

APC BE350G – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 2 – Connect the Battery; Wall Mount Installation; Battery Backup + Surge Protection Outlets
  • Page 3 – PowerChute; Overview; Install PowerChute
  • Page 4 – Operation; Energy Saving Master and Controlled by Master Outlets; Illuminated LED Flashes
  • Page 5 – Status Indicators; Status
  • Page 6 – Voltage Sensitivity Adjustment; Standby; Program; LED Flashes
  • Page 7 – Troubleshooting; Problem and Possible Cause; The Back-UPS will not turn on; Connected equipment loses power
  • Page 8 – APC Customer Support Worldwide; Use only approved APC replacement battery cartridge.; Internet
Loading the manual

Installation Guide
Back-UPS

BE750G Series

Specifications

Inventory

Safety

This UPS is intended for indoor use only.

Do not operate this UPS in direct sunlight, in
contact with fluids, or where there is
excessive dust or humidity.

Be sure the air vents on the UPS are not
blocked. Allow adequate space for proper
ventilation.

The battery typically lasts for two to five years. Environmental factors impact
battery life. Elevated ambient temperatures, poor quality utility power, and frequent
short duration discharges will shorten battery life.

Connect the Back-UPS power cable directly to a wall outlet. Do not use surge
protectors or extension cords.

Input

Voltage

120 Vac

Nominal

Frequency

50 Hz/60 Hz auto sensing

Brownout Transfers

92 Vrms Typical

Over-voltage Transfer

139 Vrms Typical

Output

UPS Capacity
(5 battery backup outlets)

750 VA, 450 W

Total Amperage (all outlets)

12 A (including UPS output)

Voltage - On Battery

115 Vrms ± 8% step approximated sine wave

Frequency - On Battery

50 Hz/60 Hz ± 1 Hz

Transfer Time

6 ms Typical, 10 ms maximum

Protection and
Filtering

AC Surge Protection

Full time, 354 Joules

Phone/DSL/FAX surge protection

Single line (2 wire)

Cable/CAT V/DSS surge protection

One coax input/output

Network surge protection

10/100 Base -T ethernet

EMI/RFI Filter

Full time

AC Input

Resettable circuit breaker

Battery

Type

Sealed, maintenance-free, lead acid
Replacement battery cartridge RBC17

Average Life

3 - 5 years depending on the number of discharge cycles and
environmental temperature

Physical

Net Weight

11 lb (5 kg)

Dimensions
Length x Width x Height

14 in x 7 in x 4 in
36 cm x 18 cm x 9 cm

Operating Temperature

32º F to 104º F (0º C to 40º C)

Storage Temperature

5º F to 113º F (–15º C to 45º C)

Operating Relative Humidity

0 to 95% non-condensing humidity

Operating Elevation

0 to 10,000 ft (0 to 3000 m)

EMC
Compliance

This device complies with part 68 and part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.

bu

0

7

5c

Back-UPS

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Connect the Battery; Wall Mount Installation; Battery Backup + Surge Protection Outlets

Installation Guide Back-UPS BE750G Series 2 Connect the Battery The Back-UPS is shipped with one battery cable disconnected. Remove the “Stop! Connect the Battery” label that covers the outlets. Prior to connecting any equipment to the unit, connect the battery cable to the unused battery terminal. ...

Page 3 - PowerChute; Overview; Install PowerChute

Installation Guide Back-UPS BE750G Series 3 Connect Modem/Telephone/DSL/FAX/10/100 Base-T Network Cable The Back-UPS protects a single line, 2 wire telephone line, including a Digital Subscriber Line (DSL), a modem, a 10/100 Base-T ethernet, or a FAX machine from power surges when connected through ...

Page 4 - Operation; Energy Saving Master and Controlled by Master Outlets; Illuminated LED Flashes

Installation Guide Back-UPS BE750G Series 4 Turn On the Back-UPS Press the Power ON button located on the top of the Back-UPS. The Power On/Replace Battery LED will illuminate green and a single short beep will be audible to indicate that the Back-UPS is providing protection for connected equipment....

Other APC Models

All APC Other