APC AR2400 - Manual

NetShelter SV User Manual 2 Safety Important Safety Information Read the instructions carefully to become familiar with the equipment before trying to assemble, operate, service or maintain it. The following special messages may appear throughout this manual or on the equipment to warn of potential ...

3 NetShelter SV User Manual Receiving and Unpacking Inspection Upon receipt, inspect the package and contents for damage. Verify the contents are complete. Report missing contents, damage, or other problems immediately to Schneider Electric or your Schneider Electric reseller. Keep all packaging for...

NetShelter SV User Manual 4 Unpacking 1. Move the shipping pallet to a firm, level surface. 2. Inspect for visible signs of shipping damage. If damage has been detected, contact Schneider Electric Customer Support using the contact information on the back cover of this manual. 3. Remove the plastic ...

5 NetShelter SV User Manual Component Identification Item Description Qty Item Description Qty  Roof 1  Leveling Feet 4  Rear Frame 1  Casters 4  Grounding wire 3  Front Frame 1  Rear Split Doors 2  Vertical Mounting Flanges 4  Side Panels 2  Door and Side Panel Keys 2  Horizontal Side Br...

7 NetShelter SV User Manual Cabinet Installation Moving the Cabinet Level the Cabinet 1. Using a 13 mm wrench, lower each leveling foot until in makes contact with the floor. 2. Adjust each foot until the equipment is level and plumb. WARNING TIP HAZARDThis cabinet is easily tipped. Use extreme caut...

NetShelter SV User Manual 8 Joining Cabinets Cabinets can be joined with or without side panels installed to provide for alignment and some stability. The cabinets are shipped with pre-installed joining brackets for 600 mm centers. To join on 24 in. centers, the cabinet is provided with 24 in. joini...

9 NetShelter SV User Manual Secure the Cabinet To secure the cabinet to the floor, use fastener locations on the outside or inside of the cabinet and the bolt-down brackets (provided). Ground the Cabinet Each cabinet should be bonded directly to a common ground using the designated grounding locatio...

NetShelter SV User Manual 10 Customize the Cabinet Reverse the Front Door You can reverse the front door so that the door is hinged on the opposite side. 1. Remove the handle using the Torx T30/#2 Phillips wrench (provided). 2. Unfasten the ground wire from the cabinet and door, then remove the door...

NetShelter SV User Manual 12 Side Panels Remove and install side panels Rear Doors Removal 1. Disconnect the grounding wires attached to the rear doors at the connector. 2. Remove the left and right rear doors by pulling the top hinge pin down to release the pin from the hole securing it to the fram...

NetShelter SV User Manual 14 Equipment Installation Adjust Vertical Mounting Flanges Vertical mounting flanges come factory-installed in the proper location for use with rack-mountable equipment. The mounting flanges are adjustable towards the front or the rear of the cabinet to fit different rails ...

15 NetShelter SV User Manual Installation 1. Use the Torx T30/#2 Phillips wrench (provided) to adjust a vertical mounting flange. Remove the T30 screws at the top, middle, and bottom of the vertical mounting flange. Save the screws for adjustment and reinstallation in the new position. CAUTION STABI...

17 NetShelter SV User Manual Installing Equipment To install rack-mount equipment in the cabinet: 1. Review the equipment manufacturer’s installation instructions. 2. Locate the top and bottom U-space on the vertical mounting rails. Every third hole on the mounting rail is numbered to indicate the m...

NetShelter SV User Manual 18 Cable Management Route, secure, and organize cables using the multiple cable access openings on the cabinet roof, sides, and bottom, the accessory mounting brackets included with the cabinet, plus the variety of cable management accessories available. Adjust Vertical 0 U...

19 NetShelter SV User Manual Specifications 42 U Cabinets AR2200 AR2400 AR2401 Height 2057 mm (81.0 in.) 2057 mm (81.0 in.) 2057 mm (81.0 in.) Width 600 mm (23.6 in.) 600 mm (23.6 in.) 600 mm (23.6 in.) Depth 1000 mm (39.4 in.) 1060 mm (41.7 in.) 1060 mm (41.7 in.) Net weight 108.8 kg (239.9 lb) 112...

NetShelter SV User Manual 24 Limited Factory Warranty The limited warranty provided by Schneider Electric in this Statement of Limited Factory Warranty applies only to Products you purchase for your commercial or industrial use in the ordinary course of your business. Terms of Warranty Schneider Ele...

Worldwide Customer Support Customer support is available at no charge via e-mail or telephone. Contact information is available at www.apc.com/support/contact . 10/2013 990-4823A-001 ©2013 Schneider Electric, APC and the APC logo are owned by Schneider Electric Industries S.A.S., or its affiliated c...