American Standard Compact 3505 - Manual
American Standard Compact 3505 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – For all other Tanks/Bowls
- Page 3 – CONNECT WATER SUPPLY; ADJUSTMENTS; REPAIR PARTS LIST; COMPACT; DESCRIPTION
- Page 4 – TROUBLESHOOTING GUIDE; AMERICAN-STANDARD ONE-YEAR LIMITED WARRANTY; this warranty does not affect such statutory rights.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Adjustable Wrench
Sealant
Tape Measure
Hacksaw
Wax Ring/Gasket
Flexible Supply Tube
Closet Bolts
Carpenters Level
1
REMOVE OLD TOILET
a.
Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.
Disconnect and remove supply line. NOTE:
If replacing valve, first shut off main water supply!
c.
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.
Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE:
Mounting surface must be clean and level before new toilet is installed!
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90
°
,
and slide into place 6" (152 mm) apart and
parallel to wall.
SAVE FOR FUTURE USE
3
2
ROUGHING-IN DIMENSIONS:
NOTE:
Distance from wall to closet flange centerline must
be as listed below:
For 4010.010/4310.016 Tanks: A = 254mm (10")
For 4014/4314 Tanks: A = 356mm (14")
For 4010.012/4392.016 and all other Tanks: A = 305mm (12")
CLOSET FLANGE
CLOSET BOLTS
7 3 0 2 3 7 - 1 0 0 R E V . Q
A
A
FINISHED WALL
FINISHED
FLOOR
SUPPLY
AS
REQ'D.
Saniwares
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY
HANDLE WITH CARE!
NOTE:
Pictures may not exactly define contour of china and components.
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
© A m e r i c a n S t a n d a r d I n c . 2 0 0 4
!
RENAISSANCE 2241
COMPACT 2149.012, 3505
COLONY 2388 / 2399 / 2359
COLONY AFTON 2329.016
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. (Certain installations may
require professional help.) Also be sure your installation conforms to local codes
INSTALLATION INSTRUCTIONS
For Two-Piece Toilets with Aquameter™ Fill Valve
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
RUBBER GASKET TANK MTG.BOLTS PRE-INSTALLED NUT WASHER WAX RING SEALANT 5 4 6 8 7a 7b INSTALL WAX SEAL Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealantaround base flange. PO...
- 3 - 7 3 0 2 3 7 - 1 0 0 R E V . Q 9 11 10 CONNECT WATER SUPPLY a. Connect water supply line between shutoff valve and tank water inlet fitting. Tighten COUPLING NUT 1/4 turn beyond hand tight. Check that refill tube is inserted into overflow tube. b. Turn on supply valve and allow tank to fill unt...
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE CORRECTIVE ACTIONDoes not flush a. Water supply valve closed. a. Open valve and allow water to fill tank. b. Supply line blocked. b. Shut off water supply, disconnect supply line, and inspect all gaskets and washers. Reassemble. c. Flush valve chain too l...
