American Standard 5032.026 - Manual
American Standard 5032.026 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
K1
© 2008 AS America Inc.
HERITAGE™ BIDET
VITREOUS CHINA
HERITAGE™ BIDET
❑
5032.026 For deck-mounted fitting (illustrated)
• Vitreous china
• Flushing rim and vertical cleansing spray
• Integral overflow
• Concealed floor anchor bracket
• Two bolt caps
Shown with 2373.401 Enfield fitting with
handles (not included)
❑
5032.010 For over-the-rim fitting
• Vitreous china
• Punched for single hole, over-the-rim fitting,
less flushing rim and spray
• Integral overflow
• Two bolt caps
Nominal Dimensions:
654 x 359 x 362mm
(25-3/4" x 14-1/8" x 14-1/4")
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures
Revised 2/08
To Be Specified:
❏
Color:
❏
White
❏
Bone
❏
Linen
❏
Bidet Fitting*:
❏
Fitting Finish:
❏
Trap:
❏
Supplies with Stops:
* See faucet section for additional models available
222mm
(8-3/4)
76mm (3)
SUGGESTED
MINIMUM
114mm
(4-1/2)
127mm
(5)
654mm
(25-3/4)
76mm
(3)
432mm
(17)
241mm
(9-1/2)
127mm
(5)
114mm
(4-1/2)
SUPPLIES
AS REQUIRED
C/L OF DRAIN OUTLET
362mm
(14-1/4)
C/L OF 3/8 HOT & COLD INLETS
203mm
(8)
102mm
(4)
FINISHED
WALL
COUPLING
NUTS ON
FITTING
359mm
(14-1/8)
29mm (1-1/8) DIA. HOLE
FOR SPRAY
44mm (1-3/4) DIA. STD.
DRAIN OUTLET
C/L
64mm
(2-1/2)
19mm
(3/4)
C/L OF (2) 8mm (5/16) DIA. FOOT
ANCHOR HOLES ON 76mm (3") CENTERS
(3) 35mm (1-3/8) DIA.
VALVE HOLES
25mm (1) DIA. HOLE
FOR POP-UP ROD
FINISHED
FLOOR
1-1/4 O.D. TAILPIECE
241mm
(9-1/2)
REF.
*
279mm
(11)
HANGER
VACUUM
BREAKER
73mm
(2-7/8)
MIN.
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES ARE SUGGESTED.
“P” TRAP AND FITTINGS NOT FURNISHED WITH BIDET AND MUST BE
ORDERED SEPARATELY. BIDET FITTING HAS TRANSFER VALVE
FEATURE.
●
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH BIDET AND
FITTING FOR ADDITIONAL INFORMATION.
PROVISIONS MUST BE MADE FOR THE INSTALLATION OF TRAP IN
FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided leaflet.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
