American Standard 4335.020.XXX - Manual
American Standard 4335.020.XXX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – MAKE WATER SUPPLY CONNECTIONS; TEST INSTALLED FAUCET
- Page 3 – REMOVE
- Page 4 – MODEL NUMBER; S I N G L E C O N T R O L K I T C H E N; PEKOE EXTENDER
S I N G L E C O N T R O L K I T C H E N
P O P - O U T S P R AY
Installation
Instr uctions
M 9 6 8 5 8 2
Certified to comply with ANSI A112.18.1M
4335.020.XXX
CAUTION
1
INSTALL FITTING
Turn off hot and cold water
supplies before beginning.
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
Channel Locks
Recommended Tools
Make certain the SEAL
(1)
is properly seated in recess
of faucet body.
Insert supply HOSES
(2)
and SHANK
(3)
through center
hole of sink or mounting surface.
Assemble RUBBER WASHER
(4)
, PLASTIC WASHER
(5)
,
METAL WASHER
(6)
and threaded LOCKNUT
(7)
onto
SHANK
(3)
from underside of sink or mounting surface.
Hand tighten LOCKNUT
(7)
and check that faucet is centered.
Use a screwdriver to tighten SCREWS
(8)
on LOCKNUT
(7)
.
Work your way around LOCKNUT
(7)
, tightening the screws
slightly each time until all are snug to ensure even pressure.
Tubing Cutter
1
2
5
RECESS
PEKOE EXTENDER
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
4
3
6
7
8
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
M 9 6 8 5 8 2 R E D S T R I P E B L U E S T R I P E 2 MAKE WATER SUPPLY CONNECTIONS Turn off hot and cold water supplies before beginning. Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection on fitting supplies are 3/8" compression. Connect left supply(Marked with a Red Stripe...
M 9 6 8 5 8 2 2 1 3 SERVICE 5 Loosen and remove LEVER HANDLE (1). Loosen HANDLE SCREW (2) with 2.5mm Hex Wrench and then pull HANDLE BASE (3) off. Unscrew ESCUTCHEON CAP (4) . Unscrew the CARTRIDGE NUT (5) and remove METAL WASHER (8) . Remove CARTRIDGE (6) . Clean inlets of CARTRIDGE (6) and MANIFOL...
MODEL NUMBER CHROMESTAINLESS STEEL 002075 Replace the "YYY" with appropriate finish code M 9 6 8 5 8 2 4335.020.XXX HOT LINE FOR HELP For toll-free information and answers to your questions, call: 1 (800) 442-1902 Weekdays 8:00 a.m. to 6:00 p.m. EST IN CANADA 1-800-387-0369 (TORONTO 1-905-30...
