American Standard 2555.900 - Manual
American Standard 2555.900 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
T O W N S Q U A R E
Certified to comply with ANSI A112.18.1M
ROUGHING-IN
DIMENSIONS
Required Tools
Wrench
(Supplied)
Turn off hot and cold water supplies before beginning.
CAUTION
1
2
Insert SPOUT SHANK (1) through center hole of MOUNTING LEDGE.
Make sure that the RUBBER RING (2) is properly seated in RECESS
at base of SPOUT (3).
Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto
SHANK (1). From underside of ledge secure SPOUT (3) into position
with LOCKNUT (6).
SPOUT ASSEMBLY
PREPARE TUBE AND TEE ASSEMBLY
Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
VALVE (2) location (between 6-1/2" and12"). If necessary,
cut and/or bend TUBING carefully. Make sure tube bend is
close to the TEE (1) so that it will not effect the compression
joint at the VALVE CONNECTION.
Remove COUPLING NUT (3) and FERRULE (4) from each
VALVE (2) and slide onto TUBING (5).
Adjustable Wrench
Channel Locks
2 5 5 5 . 9 0 0
2 5 5 5 . 9 0 1
Flat Blade Screwdriver
VALVE inlet is 3/4-inch NPT male connector.
NOTE
2
ADJ. 6-1/2 TO 12
4
3
1
3
4
5
RECESS
3
1
2
4
6
5
MOUNTING
LEDGE.
MOUNTING
SURFACE
8-1/4
3-5/8
4
ADJ. 6-1/2 TO 12
1-1/2 MAX.
1-1/4
MAX.
1-3/16 D.
3
(H)
(C)
1-1/8 D.
3/4-14 MALE
N.P.T. INLETS
12 MAX
1-1/16 D.
Phillips Screwdriver
. 3 F W
D E C K - M O U N T B A T H F I L L E R
w i t h
EverClean™ Finish
Congratulations on purchasing your American
Standard faucet with EverClean finish found
only on American Standard faucets.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
IMPORTANT NOTICE TO INSTALLER!
Please check with local Code Authority for the installation requirements of this product. Some codes require an
additional temperature mixing valve to limit the maximum hot water temperature
and vacuum breaker
(for products with hand spray)
to be installed with this product.
Installation
Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
