American Standard 2555.501 - Manual
American Standard 2555.501 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
P R E S S U R E B A L A N C I N G S H O W E R S E T
. 3 & 7
Certified to comply with ANSI A112.18.1
Installation
Instructions
T O W N S Q U A R E
2555.501
THREADED INLETS (STOPS)
INLETS
1/2" NPT
5-7/8"
OUTLETS
1/2" NPT
3-3/8"
1-5/8" TO 3-1/4"
FINISHED WALL
74" FOR
HEAD CLEARANCE
2" REF.
40" to 54"
SHOWER ONLY
OPTIONAL
1/2" I.P.S.
1
7-5/8"
BOTTOM OF
SHOWER
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65'' AND 78''
"SEE ILLUSTRATION"
8" REF.
COLD
HOT
1
5
4
3
2
1
ROUGHING-IN
Turn off water at main supply.
CAUTION
When soldering, remove PLASTER GUARD, CARTRIDGES and CHECK STOPS (IF PRESENT). When finished soldering,
flush valve body, replace cartridges, check stops (if present) and plaster guard to continue installation. Use thread
sealant or Teflon tape on threaded connections.
NOTE
Connect hot and cold water supplies.
Cap off shower pipe (4).
For support, use pipe BRACES (5) secured to wooden braces.
With valve turned off, turn on water supplies. Check for leaks.
If the valve is installed on a fiberglass
or other thin wall application, the
PLASTER GUARD (3) can be used as a support.
Cut a 4" dia. hole in the shower stall.
Drill two additional 1" holes to allow access
to the stops.
Remove PLASTER GUARD (3), rotate 90
˚
so that indicated screw holes fit MANIFOLD (2).
Push CAP on valve, place ESCUTCHEON on and
attach with screws.
See Roughing-in diagram before starting.
Connections are:
1/2" female NPT for threaded inlets
Connect RISER PIPE (1) to MANIFOLD (2)
top outlet marked "SHR".
For proper positioning the finished wall
must be within side wall of PLASTER
GUARD (3).
To assure proper positioning in relation to wall, note
roughing-in dimensions.
ROUGHING-IN DIMENSIONS
Adjustable Wrench
Channel Locks
Flat Blade Screwdriver
Plumbers' Putty or Caulking
Phillips Screwdriver
Required Tools
w i t h
EverClean™ Finish
Congratulations on purchasing your American Standard faucet with
EverClean finish found only on American Standard faucets.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
EverClean Finish
• One wipe effortlessly removes spots
• Eliminates the need for cleaners and scrubbing
• Permanent surface protectant remains beautiful
for the life of the faucet
• EverClean™ available on: Polished Chrome, Satin Nickel,
Stainless Steel, Polished Brass (or any combination of these finishes)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
