American Standard 2175.503 - Manual
American Standard 2175.503 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – MAKE WATER SUPPLY AND WASTE CONNECTIONS; HOT; COLD; ATTACH CABLE CONNECTOR
- Page 4 – SERVICE
- Page 5 – Speed ConnectTM Drain; Troubleshooting Guide; CABLE ADJUSTMENT PROCEDURE; If Stopper does not raise up fully or sink drains too slowly:; STOPPER REMOVAL PROCEDURE
- Page 6 – STOPPER INSTALLATION PROCEDURE; rear; “Locked”; front; “Unlocked”; Unlocked Mode
C O L O N Y S O F T
2175.503
Turn off hot and cold water
supplies before beginning.
CAUTION
1
Certified to comply with ANSI A112.18.1
Installation
Instructions
S i n g l e C o n t r o l L a v a t o r y F a u c e t
with Speed Connect™ Drain
INSTALL FAUCET
Adjustable Wrench
Screwdriver
Channel Locks
Recommended tools
Tubing Cutter
Congratulations on purchasing your American Standard faucet with the
Speed Connect drain, a feature found only on American Standard faucets.
Speed Connect Drain*
• 1/3 of the parts, installs in 1/3 of the time
• No tools needed
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Fig.
A.
Fig.
B.
1
Plumbers' Putty or Caulking
(HAND TIGHTEN)
3
1
2
4
3
Insert FAUCET
(1)
and CABLE CONNECTOR
(2)
through center hole
of mounting surface.
Fig.
A.
From under side of mounting surface thread the two MOUNTING
NUTS
(2)
onto FAUCET SHANKS
(4)
.
Fig.
B.
Center FAUCET
(1)
and hand tighten MOUNTING NUTS
(3)
to
secure FAUCET
(1)
.
Apply a bead of putty along the edge of the underside of the FAUCET
(1)
.
PUTTY
M 9 6 8 8 8 2 R e v. 1 . 3
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Connect HOT water supply to inlet of left SHANK and COLDwater supply to right SHANK using sealant, appropriateconnectors, and COUPLING NUTS. Connect 1-1/4” O.D. TAILPIECE (4) on POP-UP DRAIN to “p” trap. 8 Connect water supply to INLET SHANKS (1) with 1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O...
3 CHECK DRAIN CONNECTIONS 10 11 12 TEST INSTALLED FITTING Operate POP-UP KNOB (5) and fill Sink with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Sink. If STOPPER (4) does not seal properly, please refer to “Troubleshooting Guide” in these instructions. Release POP-UP K...
Speed Connect™ Drain Troubleshooting Guide 1 2 Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration. Fig. B. Use ...
