American Standard 2175.502 - Manual
American Standard 2175.502 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE; HOT
- Page 4 – SERVICE; If Faucet Drips Proceed As Follows:
- Page 5 – SpeedConnectTM Drain; Troubleshooting Guide; CABLE ADJUSTMENT PROCEDURE; If Stopper does not raise up fully or sink drains too slowly:; STOPPER REMOVAL PROCEDURE; DOWN
- Page 6 – STOPPER INSTALLATION PROCEDURE; “Locked”; Unlocked Mode
C O L O N Y S O F T
2175.502
Turn off hot and cold water
supplies before beginning.
CAUTION
Insert FAUCET
(1)
and CABLE CONNECTOR
(2)
through center hole
of mounting surface.
Fig. A.
From under side of mounting surface thread the two MOUNTING
NUTS
(2)
onto FAUCET SHANKS
(4)
.
Fig. B.
Center FAUCET
(1)
and hand tighten MOUNTING NUTS
(3)
to
secure FAUCET
(1)
.
1
Certified to comply with ANSI A112.18.1
I n s t a l l a t i o n
I n s t r u c t i o n s
S i n g l e C o n t r o l L a v a t o r y F a u c e t
with SpeedConnect™ Drain
INSTALL FAUCET
Adjustable Wrench
Screwdriver
Channel Locks
Required tools
Tubing Cutter
Congratulations on purchasing your American Standard faucet with
SpeedConnect drain, a feature found only on American Standard faucets.
*Your new American Standard faucet is designed to work only with the SpeedConnect drain.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Fig. A.
Fig. B.
1
M 9 6 8 8 8 1
Plumbers' Putty or Caulking
(HAND TIGHTEN)
3
1
2
4
3
SpeedConnect Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
Apply a bead of putty along the edge of the underside of the FAUCET
(1)
.
PUTTY
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
M 9 6 8 8 8 1 COMPRESSION NUT 3/8” COMPRESSION CONNECTION COUPLING NUT FLEXIBLE SUPPLIES 3/8 O.D. BULL-NOSE RISERS Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instruction...
3 2 10 TEST INSTALLED FITTING 5 2 CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshootingsection in these instructions. Release...
M 9 6 8 8 8 1 SpeedConnect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration. Fig...
