American Standard 0178.027 - Manual
American Standard 0178.027 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
J5
© 2008 AS America Inc.
LEXINGTON™
PEDESTAL SINK
VITREOUS CHINA
LEXINGTON™ PEDESTAL SINK
• Minimalistic styled pedestal sink
• Made from vitreous china
• Rear overflow
• Supplied with mounting kit
• Faucet ledge
Shown with 8871.902 Amarilis faucet with
Lexington handles (not included)
❏
0178.514 Faucet holes on 8" (203mm) centers
(Illustrated)
❏
0178.536 Center Hole only
Nominal Dimensions:
616 x 464 x 867mm
(24-1/4" x 18-1/4" x 34-1/2")
Separate Components:
❏
0178.027 Pedestal top-8" (203mm) centers
❏
0178.152 Pedestal top-center hole only
❏
730500-400 Pedestal only
Bowl sizes:
445mm (17-1/2") wide
276mm (10-7/8") front to back
143mm (5-5/8") deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures
To Be Specified:
❏
Color:
❏
White
❏
Bone
❏
Linen
❏
Silver
❏
Fawn Beige
❏
Black
❏
Faucet*:
❏
Faucet Finish:
❏
Supplies:
❏
1-1/4" Trap:
* See faucet section for additional models available
NOTES:
*
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
▼
PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■
SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKE FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.2.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
OPEN TO
FLOOR
DRAIN
CHASE
876mm
(34-1/2)
FINISHED
WALL
203mm
(8)
464mm
(18-1/4)
197mm
(7-3/4)
PEDESTAL ANCHOR
SCREW HOLES
(2)10mm (3/8) DIA.
565mm
(22-1/4)
70mm
(2-3/4)
FINISHED
FLOOR
187mm
(7-3/8)
330mm
(13)
178mm
(7)
1-1/4 O.D.
WASTE
10mm
(3/8)
254mm
(10)
19mm (3/4) DIA.
HOLES FOR
ANCHOR BOLTS
203mm
(8)
610mm
(24-1/4)
102mm
(4)
*
286mm
(11-1/4)
*
178mm
(7)
SUPPLIES AS
REQUIRED
1-1/4 O.D.
TAILPIECE
Revised 2/08
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
