American Audio V4000 plus - Manual

1. Power Switch - This switch is used to control the units main power. 2. Channel 1 Gain Control - This rotary knob is used to control the out- put signal of channel one. Turning the knob in a clockwise direction will increase signal output. 3. Channel 1 Limiter Switch - This is used to activate the...

16 32 28 15 29 27 33 26 25 24 23 22 20 21 18 19 17 15 Rear Panel Control 15. Cooling Fans - Dual high speed cooling fans 16. Channel 2 TRS Input - Channel two 1/4” female jack. Excepts ei- ther a balanced or unbalanced plug. See page 7 for more details. 17. Channel 2 XLR Input - Channel two 3-pin XL...

Unbalanced TS 1/4” Plug Hot (+) Negative (-) Diagram 5 Balanced TRS 1/4” Plug Ground/Shield Hot (+) Negative (-) Diagram 4 2 Hot (+ data) 3 Negative (- data) 1 Ground/Return/ 0v) 1 2 3 Male XLR Pin Confi gu Male XLR Pin Confi Male XLR Pin Confi ration: US ITT Standard Diagram 3 OUTPUTS:Binding Post/...

Bare Wire Connections: When connecting your speakers to the amplifier using bare wire; Unscrew the red and black caps on the binding post, be sure not to completely remove or unscrew the red and black caps. Strip back the wire insulation 1/2” (13mm). Insert the bare wire into the hole that was revel...

OPERATING MODES: Always configure your amplifier operating mode before beginning operation. If you want to change it dur- ing performance. You must decrease the gain controls to their lowest levels to protect the speakers from any popping noise. Stereo Operation - Page 10/Figure 9 details an example...

put). Short Circuit Protection can usually be traced back to the signal output line (i.e. speaker line). Check the line from the output terminal of the amplifier to the speaker. If this line good, check the internal speaker connections and components. A short circuit will usually be traced to a bad ...

Positive (+) Lead Negative (-) Lead Do Not Use Ch2 Inputs Do Not Use Ch2 Inputs Use Ch1 Inputs Use Ch1 Inputs Set to Bridge Set to Subwoof Use Ch2 Inputs Use Ch2 Inputs Use Ch1 Inputs Use Ch1 Inputs Set to Stereo Set to Subwoof Set to Subwoof Figure 14 Figure 15 Use either the Speakon or the banana ...

TYPICAL MONO BRIDGE SET-UP SPEAKERS 4 OHM MINIMUM TYPICAL STEREO OUTPUT CONNECTIONS SPEAKERS 2 OHM MINIMUM SPEAKERS 2 OHM MINIMUM Use Channel 1 Inputs Only (XLR or 1/4” Jacks) X X X X X X X X Use Speakon or Banana Jacks ©American Audio® - www.americandj.com - V4000plus™ Power Amplifier User Manual P...

Output Power: 2 ohms, 1 khz 1% THD 2 ohms, 1 khz 1% 2 ohms, 1 khz 1% 4 ohms, 1khz, 1% 4 ohms, 1khz, 1% 4 ohms, 1khz, 1% THD 8 ohms, 1khz 1% THD 8 ohms, 1khz 1% 8 ohms, 1khz 1% (Bridge Mode, mono) 4 ohms, 1khz, 1% THD 4 ohms, 1khz, 1% 4 ohms, 1khz, 1% 8 ohms, 1khz, 1% THD 8 ohms, 1khz, 1% 8 ohms, 1kh...