Amana MDK01E- Installation Manual
Amana MDK01E– Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Dimensions; TOP; Hole Placement Template
- Page 3 – MDK Installation Instructions; Cabinet Front Removal; WARNING; disconnect power; TRANSITION; Transition Assembly
- Page 4 – Install chassis back into wall sleeve.; Wall Sleeve Hole Placement; If there is not enough clearance between; Mounting Brackets Installation; RIGHT SHIFT
- Page 5 – BAFFLE; Table 1; Air Baffle Installation Instructions; Air Grille Installation; MDK ASSEMBLY; MDK Installation Onto Transition Assembly; Do not apply pressure on top of duct during; Main Supply Duct Top Flange; Total length of duct extension assembly, including field
- Page 6 – Main Duct and Duct Extension Dimensions; see Main Supply Duct Top Flange illustration
- Page 7 – TDK Installation Instructions; IMPORTANT NOTE; Wall Hole Dimension; GASKET; Sheet Metal Collar; USE; Metal Grille; Insert the sheet metal collar into the wall so that the
The kit consists of a main duct for the room of origin and an extension duct to reach the adjoining room, and terminal
duct.
NOTE:
All required hardware is provided within kit.
PTAC DUCT KIT
I
NSTALLATION
I
NSTRUCTIONS
Extends air distribution to an adjoining room.
Part No. 11113404
Printed in USA
September 2004
TRANSITION
BAFFLES
**
**
**
**
Terminal Duct Kit - TDK02
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the product better than the customer. This
includes all safety precautions and related items.
Prior to actual installation, thoroughly familiarize yourself with this Instruction Manual. Pay special
attention to all safety warnings. Often during installation or repair it is possible to place yourself in a
position which is more hazardous than when the unit is in operation.
Remember, it is
your
responsibility to install the product safely and to know it well enough to be able to
instruct a customer in its safe use.
Safety is a matter of common sense...a matter of thinking before acting. Most dealers have a list of
specific good safety practices...follow them.
The precautions listed in this Installation Manual are intended as supplemental to existing practices.
However, if there is a direct conflict between existing practices and the content of this manual, the
precautions listed here take precedence.
Extension Duct Kit - EDK02
Main Duct Kit - MDK02
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 OUTSIDE WALL WALL SLEEVE UNIT FRONT END OFDUCTEXTENSION 1/2" TRANSITION 2-3/4" MIN (FOR SUBBASE KIT) 1/4" MIN 7-1/2" 18-3/8" 5" FLOOR LINE SUBBASE KIT INNER WALLCUT-OUT BOTTOM OF WALL SLEEVE 2-3/8" MIN (FOR DUCT KIT) 3-1/4" MIN 10" 20-1/2" MAX Installation D...
3 MDK Installation Instructions 1. If the cabinet front is screwed to the chassis, removethe screw located behind the inlet grille. Pull the inletgrille forward from the top of the grille to access twoscrews. 2. Remove cabinet front from chassis by tilting the bot-tom of the front forward, lifting s...
4 P RE -A SSEMBLY (W ALL S LEEVE ) H OLE D IMENSION AND P LACEMENT 1. Unplug and remove chassis from wall sleeve. Drill two1/8” holes on left and right sides of wall sleeve inproper locations (see template on page 2). 2. Install chassis back into wall sleeve. 3. Install transition/front assemby on t...
