Alto-Shaam AS-250 - Manual
Alto-Shaam AS-250 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – D E L I V E R Y
- Page 4 – C A U T I O N; This appliance is intended to cook, hold; N O T E
- Page 5 – S I T E I N S T A L L A T I O N; The oven must be installed on a stable and; TO PREVENT PERSONAL INJURY,; D A N G E R; I N S T A L L A T I O N; MINIMUM CLEARANCE
- Page 6 – W E I G H T; O P T I O N S & A C C E S S O R I E S
- Page 7 – LEG INSTALLATION INSTRUCTIONS; Bottom View; Item; to bottom of unit using four (4) nylon screws; WARNING; Failure to properly install the
- Page 8 – E L E C T R I C A L C O N N E C T I O N; E L E C T R I C A L
- Page 9 – SEVERE DAMAGE OR; WARRANTY BECOMES VOID IF; O P E R A T I N G I N S T R U C T I O N S; U S E R S A F E T Y I N F O R M A T I O N; Wipe all wire shelves, side racks and the full oven; A U D I B L E S I G N A L S; One brief beep - response to a key being pressed.
- Page 10 – CONTROL FEATURES
- Page 11 – To stop an operation at any time; — Press and hold; To turn oven control panel off; — Press and hold the; Door open indicator; Key at the same time.; Green and Amber Indicators:; recommended that you ensure the food is safe for; To verify product probe calibration, place the; O P E R A T I N G F E A T U R E S & F U N C T I O N S; WAIT ONE FULL MINUTE
- Page 12 – Cook/Hold Instructions; Key. The display will; To Cook/Hold using Preset Menu Keys
- Page 13 – Programming a Preset; Erasing a Preset; IMPORTANT
- Page 14 – General Holding Guideline
- Page 15 – C A R E A N D C L E A N I N G; PROTECTING STAINLESS STEEL SURFACES; It is important to guard against corrosion; CLEANING AGENTS; C L E A N I N G A N D P R E V E N T I V E M A I N T E N A N C E
- Page 17 – CENTER FOR FOOD SAFETY AND APPLIED; S A N I T A T I O N
- Page 18 – T R O U B L E S H O O T I N G; S E R V I C E; Possible Cause; To test probe and air sensor:
- Page 19 – Verify that power is available at the outlet or junction box.; B. Display is lit and unit calls for heat, but unit is not heating; This is a safety; should be 100 ohms resistance.; T R O U B L E S H O O T I N G I N T E R N A L E L E C T R I C A L C O M P O N E N T S; untrained or unauthorized service personnel. If your Alto-Shaam; authorization by Alto-Shaam
- Page 20 – A S - 2 5 0 - E X T E R I O R S E R V I C E V I E W
- Page 21 – S E R V I C E V I E W - P A R T S L I S T; L O C K - O U T O R P O S T
- Page 24 – T R A N S P O R T A T I O N D A M A G E a n d C L A I M S; L I M I T E D W A R R A N T Y
M N - 2 8 8 6 0 • 0 1 / 1 1
p r i n t e d
i n
u
.
s
.
a
.
C o o k i n g & H o l d i n g O v e n
E l e c t r i c M a n u a l C o n t r o l
Model:
AS-250
• INSTALLATION
• OPERATION
• MAINTENANCE
W164 N9221 Water Street • P.O. Box 450 • Menomonee Falls, Wisconsin 53052-0450 USA
PHONE: 262.251.3800 • 800.558.8744
u s a
/
c a N a d a
FAX: 262.251.7067 • 800.329.8744
u
.
s
.
a
.
o n l Y
www.alto-shaam.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
AS-250 in StAl lAtion / oper Ation / Ser vice mAn uAl pg . 1 D E L I V E R Y This Alto-Shaam appliance has been thoroughly tested and inspected to ensure only the highest quality unit is provided. Upon receipt, check for any possible shipping damage and report it at once to the delivering carrier. S...
pg . 2 AS-250 in StAl lAtion / oper Ation / Ser vice mAn uAl C A U T I O N Used to indicate the presence of a hazard that can or will cause minor personal injury, property damage, or a potential unsafe practice if the warning included with this symbol is ignored. C A U T I O N Used to indicate the p...
AS-250 in StAl lAtion / oper Ation / Ser vice mAn uAl pg . 3 S I T E I N S T A L L A T I O N The Alto-Shaam cook and hold oven must be installed in a location that will permit the oven to function for its intended purpose and to allow adequate clearance for ventilation, proper cleaning, and maintena...