Aiphone GT-VAX - Manual
Aiphone GT-VAX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
- INSTRUCTIONS -
The GT-VAX is a video module that provides a connection for up to 2 external CCTV cameras for viewing
the area surrounding the GT entrance panel. When a visitor calls from the entrance station, the view from
the separate CCTV camera will be seen on the tenant's monitor station. The tenant has the option to switch
over to a second CCTV camera (if equipped). The GT-VAX module will be installed in the entrance panel,
but will not be seen.
CCTV Interface Module for GT Multi-Unit Video Entry System
WIRING DIAGRAM:
ENTRANCE PANEL CONFIGURATION:
1. The GT-VAX module takes the place of the standard GT-VA module, and must be located in the entrance
panel.
2. A blank plate (GF-BP) is required to cover the GT-VAX, so it will be out of sight from the outside of the
panel.
3. The remote CCTV camera (powered locally) connects to the back of the GH-VAX module as shown
below. The camera location is intended to provide a wider view of the lobby or entry area, other than a
direct frontal view of the visitor.
4. Build the remainder of the GT entrance panel in the same manner as any other GT station, with the GT-
DA-L Audio Module connected directly with the GT-VAX, then all other modules connected as
designated in the GT Installation & Operation Manual.
5. Programming and operation of the GT entrance panel when using the GT-VAX CCTV interface module is
the same as a standard GT panel.
A1 A2
Black wire
(video in, ground)
Yellow wire
(video in, +)
GT-VAX w/ GT-DA-L
(rear view)
CCTV Cameras
(powered locally)
Coax
GT-VAX:
This unit is used in place of a standard
GT-VA, so there is no camera built into
the entrance panel. The only video is
from the external CCTV camera(s).
Video wire #871802
R1
R2
ELB
ELC
ELM
BP
BP
CN2
CN1
ON
SW2
1
2
3
4
VR1
Audio wire #872002
GT
-V
BC
+
-
GT-
B
C
-
+
-
Distribution
Point
R1/R2 to
Tenant
PS
B1/B2 to
Tenant
To GT-SW
or GT-NS
1011
ON
1
2
3
4
SW3
CN6
ON
1
2
3
4
SW1
Coax
Brown wire
(video in, +)
Red wire
(video in, ground)
Default Camera
Secondary Camera
If only using 1 CCTV camera,
connect it to the Yellow and Black
wires. The secondary camera to
the Brown and Red wires will be
used if you desire another camera
in the lobby area and the ability to
switch between the two cameras.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
