Page 4 - © Copyright AEG 2009. All rights reserved.
4 etc. entered into by AEG and its representatives without prior notification in the event of maintenance and repair work being carried out with anything other than original AEG spare parts or spare parts purchased by AEG. Handling PROTECT HOME. is designed and constructed so that all necessary step...
Page 5 - Certification
Page 6 - Safety; Important Safety Instructions; Identifies risk of fatal injury to the operator.; Safety Instructions for PROTECT HOME.
6 2 Safety 2.1 Important Safety Instructions Read these operating instructions carefully prior to commissioning of the PROTECT HOME. UPS and observe the safety instructions! Only use the unit if it is in a technically perfect condition and always in accordance with its intended purpose, while being ...
Page 7 - Never connect the mains input to the UPS output!
7 The output may be live, even if the UPS is not connected to the mains supply, as the UPS has its own internal power supply (battery)! For health and safety reasons, the unit must be earthed correctly! PROTECT HOME. may only be operated with or connected to a 230 VAC mains with protective grounding...
Page 10 - System Description; Battery charger for charging the battery
10 3 System Description i PROTECT HOME. is an uninterruptible power supply (UPS) for essential loads such as personal computers (PCs), satellite TV’s, telecommunication equipment and similar devices. It consists of: ♦ Mains filter in the mains input incl. mains energy back feed protection ♦ Battery ...
Page 11 - UPS overview; Top view; USB interface
11 4 UPS overview Connections, Operation / Display Elements: Top view Side view Power switch of the UPS (mains switch) Green LED:Normal / power mode Yellow LED: Battery mode Red LED: Warning / failure Surge protected only receptacles (without UPS protection) Battery power supplied receptacles (with ...
Page 12 - Specifications
12 4.1 Specifications MODEL PROTECT HOME. Type power 600 VA / 300 W Input voltage 230 Vac ( 1ph ~ / N / PE ) Input voltage range without battery mode + 6% / - 10% Frequency (auto selection) 50 / 60 Hz ± 5 Hz UPS-input power consumption 3.0 A max. Rated output voltage /AVR-technology 230 Vac Rated ou...
Page 13 - Guidelines; The PROTECT HOME. complies with the product norm EN 50091.
13 Backup mode Sounding every 5 seconds Overload Sounding every second Battery replacement Sounding 2 times per seconds Acoustic alarm Fault UPS Continuously sounding Size W x H x D 125 mm x 85 mm x 300 mm Weight 3.5 kg Operating temperature range 0° - 40°C Relative humidity 20% – 90 % Protection ty...
Page 14 - Installing the UPS is as easy as following the steps shown.; Inspection
14 5 Set-Up and Operation Installing the UPS is as easy as following the steps shown. 5.1 Inspection Remove the UPS from its packaging and inspect it for damage that may have occurred during shipping. If any damage is discovered, repack the unit and return it to the place of purchase. 5.2 Placement ...
Page 16 - In
16 Do not plug heaters or other large electrical device with high power consumption into the UPS. The power demands of these devices will overload and can execute the input fuse of the PROTECT HOME. 5.6 Modem / Phoneline Connection Plug incoming internet line into the “In” socket at the side panel o...
Page 17 - The connection vie the USB connector will be auto detected.; DC Start Function; USB
17 The connection vie the USB connector will be auto detected. 5.9 Turn On/Off To turn on the PROTECT HOME., press the on/off switch. To turn off the PROTECT HOME., press the on/off switch again. 5.10 DC Start Function The DC Start Function enables UPS to be started up when AC utility power is not a...
Page 18 - Battery removal
18 5.12 Battery removal Battery replacement should be performed by qualified service personnel. Keep unauthorized persons away from the batteries! Disconnect all power sources before battery replacement. Follow Fig. 1 below to remove the screws located on the bottom of the UPS to open the battery co...
Page 19 - Shutdown- and UPS management software
19 5.13 Shutdown- and UPS management software The "CompuWatch" software specially developed for these purposes by AEG continuously checks the mains supply and the UPS status. In conjunction with the "intelligent" UPS, this ensures that the availability of IT components and data secur...
Page 20 - Trouble shooting
20 6 Trouble shooting Error Cause Remedy Yellow LED is lighting, but audible alarm is heard intermittently. UPS not connected properly to the mains. Connect the UPS according to the installation guide. UPS is functioning but audible alarm is heard periodically. UPS overload. Verify that the load mat...
Page 21 - Guarantee certificate; Trading stamp / Signature; AEG Power Solutions GmbH
21 Guarantee certificate Type: …….…………………...................................................... Serial-no.: ……………………..……………............................... Date of purchase: …………….............……………………........ Trading stamp / Signature Specifications are subject to change without notice. AEG Power Sol...
