ADTRAN 3100 Series - Manual

Quick Start Guide, 61700600L2-13A, July 2006

Technical Support 1-888-4ADTRAN (1-888-423-8726)

Copyright © 2006 ADTRAN, All Rights Reserved

For more detailed documentation, visit us online at

www.adtran.com

.

Quick Start Guide

®

NetVanta 3100 Series Router

P/N 1700600L2, 1700610L2

STAT

ETH1

VPN

DBU

1

2

SWITCH

NetVanta 3120

3

4

NetVanta 3120 Front Panel Layout

G

ETTING

S

TARTED

Two configuration methods are available for your NetVanta router:

•

Web-based GUI

•

AOS Command Line Interface (CLI)

The GUI lets you configure the main unit settings and provides online guidance and explanations
for each setting. However, using the AOS CLI may be necessary for more advanced
configurations.

A

CCESS

THE

GUI

You may access the web-based GUI from any web browser on your network by following these
steps:

1.

Connect the router to your PC using one of the four switch ports on the back of the unit.

2.

During bootup your PC will obtain an IP address from the NetVanta 3100 Series unit’s DHCP
server. By default, both the DHCP and HTTP servers are enabled.

3.

Enter the unit’s IP address in your browser address line. The default IP address is

10.10.10.1

.

4.

You will then be prompted for the username and password (the default settings are

admin

and

password

).

5.

The initial GUI screen appears.

6.

Click on

Getting Started

in the

System

menu on the left side of your screen and follow the

on-line instructions.

C

ONFIGURE

THE

ATM PVC (N

ET

V

ANTA

3130 O

NLY

)

1.

Click on the

Getting Started

link under the

System

menu. This brings up a side bar page.

2.

Click on

Step 1 - Configure the Public Interface

at the top of the side bar page to open the

ATM PVC

page.

3.

Enter the PVC number and select an

Interface Mode

. Usually this is PPP or PPPoE;

however, if

IP routing

is chosen, you will need to enter an IP address.

4.

Click

Apply

. If PPP or PPPoE is selected as the

Interface Mode

, you will be taken to the

PPP

page after clicking

Apply

. Here you will need to select the type of authentication

needed, authentication passwords, and the

Address Type

. In most cases you will want the

Address Type

to be

Negotiated

. Click

Apply

when all the information is complete.

A

CCESS

THE

CLI

If needed, you can access the AOS CLI via a Telnet session.

1.

Telnet to the unit’s IP address. The default IP address is

10.10.10.1

.

2.

You will then be prompted for the username and password (the default settings are

admin

and

password

).

3.

Enter

enable

at the

>

prompt.

4.

Enter the enable password when prompted. The default password is

password

.

uy

For security purposes, you should set up an

admin

password

immediately. Use the

Passwords

page of the Web GUI to change this

password.

By default, the NetVanta 3130 comes with an ADSL and an Asynchronous
Transfer Mode (ATM) port already configured and enabled. The service
provider should provide a PVC (VPI/VCI) number which will be used to
configure the ATM PVC.

STAT

WAN

VPN

DBU

1

2

SWITCH

NetVanta 3130

3

4

NetVanta 3130 Front Panel Layout