ADTRAN 1280050L1 - Manual
ADTRAN 1280050L1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
TRACER ETHERNET SWITCH MODULE
P/N 1280050L1
For more detailed documentation, visit us online at
www.adtran.com
Quick Start Guide
Quick Start Guide, 61280050L1-13A, January 2005
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Copyright
©
2005 ADTRAN, All Rights Reserved
S
PECIFICATIONS
Interface Type:
(4) 10BaseT/100BaseTX interfaces with auto MDI/MDIX
crossover on all interfaces
Flow Control:
Back-pressure flow control on all half-duplex interfaces
Pause-frame flow control on full-duplex interfaces
Environmental
Specifications:
Operating Temperature: -25°C to 65°C
Storage Temperature: -20°C to 70°C
Relative Humidity: Up to 95% non-condensing
Compliance:
FCC Part 15, Class A
N
ETWORK
C
ONNECTION
P
INOUT
Pin
Name
Source
Description
1
RX1
Attached Equipment
Receive Positive
2
RX2
Attached Equipment
Receive Negative
3
TX1
Module
Transmit Positive
4, 5
UNUSED
N/A
—
6
TX2
Module
Transmit Negative
7, 8
UNUSED
N/A
—
I
NSTALLATION
I
NSTRUCTIONS
1.
Remove the cover plate from the appropriate option slot in the TRACER
rear panel.
2.
Slide the TRACER Ethernet Switch Module into the option slot until the
module is firmly positioned in the chassis.
3.
Secure the thumbscrews at both edges of the module. Tighten with a
screwdriver.
4.
Connect the cables to the associated device(s).
5.
Complete installation of remaining modules and system as specified in
the TRACER 6000 Series System Manual.
The TRACER Ethernet Switch Module is not
hot-swappable. Remove power from the TRACER
system before installing or removing the module.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
