A&D HL-3000LWP - Manual - manualsarea.com

Page 2 - SAFETY PRECAUTIONS

1 SAFETY PRECAUTIONS All safety messages are identified by the following, “WARNING” or “CAUTION” , of ANSI Z535.4 (American National Standard Institute: Product Safety Signs and Labels). The meanings are as follows: WARNING A potentially hazardous situation which, if not avoided, could result in dea...

Page 3 - PARTS DESCRIPTION

2 PARTS DESCRIPTION Weighing Platform ON/OFF key Turns the scale power on/off. UNITS key (U.S.A. models only) Changes weighing units. RE-ZERO key Sets display to zero or subtracts weight of container. Spirit level Display Four leveling feet Battery cover Battery compartment AC adapter jack (Batterie...

Page 4 - PREPARATION; Installing Batteries / Connecting The AC adapter

3 PREPARATION Installing Batteries / Connecting The AC adapter Installing Batteries CAUTION When replacing batteries, be careful not to apply too much force to the weighing pan. An excessive force could damage the scale. Remove the battery cover and insert six batteries (R6P / LR6 / AA size) into th...

Page 5 - WEIGHING; Before weighing; Automatic Power-Off Function; Calibration may be required before weighing; Weighing procedures

4 WEIGHING Before weighing Automatic Power-Off Function If the scale is left ON and the stable indicator is displayed, the automatic power-off function turns the power off after approximately 5 minutes (factory setting). To toggle the function disabled/enabled, press the [ON/OFF] key while pressing ...

Page 6 - CALIBRATION; When to calibrate; The position of the [UNITS] key for the Calibration; Calibration using a calibration weight

5 CALIBRATION When to calibrate Calibration may be required when the scale initially installed, if it is moved a substantial distance, or in accordance with local regulations. This is necessary because the weight of a mass in one location is not necessarily the same in another location. Also, with t...

Page 7 - Gravity compensation; Set the new value

6 Gravity compensation If you have calibration weights at the capacity of the scale, you can calibrate the scale with the weights instead of compensating for acceleration due to gravity. The scale was calibrated at 9.798 m/sec 2 , at the factory. If the acceleration due to gravity at your location i...

Page 8 - SPECIFICATIONS; The Value of Gravity at Various Locations

7 SPECIFICATIONS MODEL HL-1000WP HL-300WP HL-3000WP HL-3000LWP 1000 x 0.5 g 300 x 0.1 g 3000 x 1 g 2.2 x 0.001 lb 6.6 x 0.002 lb 35.28 x 0.02 oz 10.58 x 0.01 oz 105.8 x 0.1 oz Capacity x Resolution 2 lb 3.3 x 0.1 oz 6 lb 9.8 x 0.1 oz Non-linearity ±1g ±0.2g ±2g Repeatability 0.5g 0.1g 1g Span drift ...

Page 9 - World Map

A&D HL-3000LWP - Manual

Table of Contents:

Summary

Other A&D Models