Actiontec V.90 - Manual - manualsarea.com

Page 2 - Table of Contents; Proprietary Notice and Disclaimer

2 Table of Contents Do This First ................................................................................................................. 3 For Windows 3.1X Installation .............................................................................. 3For Windows 95/98 Installation ............

Page 3 - Do This First; Please read the following tips carefully before attempting to; For W; INDOWS

3 Do This First Please read the following tips carefully before attempting to install your new modem. For W INDOWS 3.1 I NSTALLATION Because Windows 3.1 and 3.11 are not Plug-N-Play operating systems, it is suggested that you do not rely on the Plug-N-Play capabilities of your com- puter to automa...

Page 6 - NT; NSTALLATION

6 Go to your system BIOS Setup routine and find the Plug-N-Play settings. These settings can be found within the Advanced , PNP/PCI Configuration , or Plug and Play Configuration sections depending on the BIOS Manufac- turer. Next, verify that one free IRQ has been set so that the ISA bus has access...

Page 7 - Installing The Modem; JUMPER SETTINGS

7 consult your computers user manual. Be sure to Save the settings before exiting the BIOS Setup. The computer will then reboot. Set your modems jumpers to COM 2 - IRQ 3. (See Jumper Settings in the Installing the Mo- dem section for jumper setting diagrams.) You are now ready to install the mod...

Page 14 - Installing and Configuring Communications Software; Installing the Modem

14 Installing and Configuring Communications Software If your modem came with a communications software package, it is strongly rec- ommended that you use this software for your modem. Its default installation parameters have been specially configured to work with this modem. The Users Guide for th...

Page 15 - Troubleshooting

15 Troubleshooting Most problems encountered during the Windows 95/98/NT installation process are a result of inadequate system resources. If you skipped some of the recom- mended preinstallation procedures outlined in the Do This First section, return to the beginning of that section and carefully ...

Page 18 - Common Problems

18 Common Problems : No Dialtone Error Make sure you have connected the phone cable into the right connector on the back of the modem. See Figure 7: Connecting Devices . You may have too many devices connected to the phone line. Remove all other equipment. Your modem may not recognize overseas dialt...

Page 20 - Appendix A: AT Command Set; AT Commands

20 Appendix A: AT Command Set AT Commands AT commands are issued to the modem to control the modems operation and software configuration. AT commands can only be entered while the modem is in command mode. The format for entering AT commands is: TYPE: ATXn where X is the AT command, and n is the sp...

Page 31 - Appendix B: Communications Regulations; FCC REGULATIONS

31 Appendix B: Communications Regulations FCC REGULATIONS The following statements are provided in accordance with the Federal Communi- cations Commission (FCC) regulations. Please read these statements carefully before installing your modem. FCC PART 68 REQUIREMENTS This equipment complies with Par...

Actiontec V.90 - Manual

Table of Contents:

Summary

Other Actiontec Models