Abocom FE2000 - Manual - manualsarea.com

Page 2 - Hardware Installation; Software Installation; on; Inserting the CardBus Dual-Speed PC Card; Insert the CardBus PC Card and push it firmly

Hardware Installation This chapter describes how to install the CardBus 10/100M dual-speed PC Card in your notebook computer and connect it to network. It’s referred to “the PC Card” in this manual. The PC Card could connect to either 100Mbps Fast Ethernet or 10Mbps Ethernet over unshielded twisted ...

Page 3 - should be paid when removing the 15-pins

- 2 - Removing the CardBus Dual-Speed PC Card It’s quite different for various computer mechanical design. Please refer to the PC Card removal instruction in the document for your notebook computer. Connecting and Removing the Cable of Media Coupler to the CardBus PC Card Grasp the PC Card 15-pins c...

Page 5 - This Chapter consists several parts:

Software Installation Extensive software drivers have been developped for CardBus 10/100M PC Card including DOS-Mode, Microsoft Windows 3.x, Windows 95, Windows NT. Some of the Operating Systems and PC Card/Socket Services haven’t been well implemented to support new CardBus technology at the presen...

Page 6 - Windows 95 Installation; Windows 95 released two major versions at the time; Determining the Version of Windows 95; After successfully booting and login the Windows; System icon; Tab, this system information

- 5 - Windows 95 Installation Windows 95 released two major versions at the time when this manual is written. The first version ( refer to “ Native Windows 95 ” afterward ) supports for 16-bit PC Card but not for CardBus PC Card. The latest version Windows 95 with OEM Service Release #2 ( refer to O...

Page 7 - Native

- 6 - Version Information here! 4.00.950 or 4.00.950a is first released Windows 95 which don’t support CardBus. Refer to Native Windows 95 section for installation. 4.00.950B is Windows 95 with OEM Service Release #2 which support both PC Card and CardBus PC Card. Refer to OSR2 Windows 95 or Later s...

Page 10 - OSR2 Windows 95 and Later; Windows 95 OSR2 and later versions support both; Next; Update Device Drivers Winzard; The; Others Locations; button

- 9 - You may need to set it up again. For more information see the network troubleshutter in the windows Help”. If you don’t need to use the CardBus 10/100 PC Card at this time, you can just ignore the message. Otherwise, you need to insert the CardBus 10/100 Ethernet PC Card into the CardBus socke...

Page 12 - Windows 98 Installation; When the CardBus 10/100 Ethernet PC Card; and click

Windows 98 Installation 1. When the CardBus 10/100 Ethernet PC Card Adapter is well inserted into the PC Card slot of your system, the following figure will appear automatically. Click Next to proceed. 2. Select Search for the best driver for your device (Recommended) and click Next. - 11 -

Page 14 - Yes

- 13 - CD-ROM, you’ll have to load it into the CD-ROM drive for the software installation need. 6. Wait for a while until the file copy process is complete. 7. Click Finish. Then the software installation is successfully complete. 8. When asked to restart your system, click Yes to activate the devic...

Page 15 - Start

- 14 - 9. To verify if the device is well installed in your system and enabled, go to Start → Settings → Control Panel → System → Device Manager. Make sure CardBus Fast Ethernet 10/100 Adapter appears as illustrated below. If not, it means your device is not properly installed. Then consult your dea...

Page 16 - Windows 2000 Installation

- 15 - Windows 2000 Installation 1. When the CardBus 10/100 Ethernet PC Card Adapter is well inserted into the PC Card slot of your system, the following figure will appear automatically. Click Next to proceed. 2. Select Search for a suitable driver for my device (recommended) and click Next.

Page 17 - Insert the device driver disk into the floppy disk; Floppy disk drives

- 16 - 3. Insert the device driver disk into the floppy disk drive. Select Floppy disk drives and click Next. 4. When the appropriate driver for the device is found, click Next to install. 5. Click Yes.

Page 19 - Windows NT 4.0 Installation

- 18 - Windows NT 4.0 Installation Assumed that the Network Services already installed in the NT 4.0 system. 1. Insert the Cardbus 10/100M Fast Ethernet PC Card into any one of PC Card Slots in system. 2. Power up Windows NT 4.0 3. Open My Computer 4. Open Control Panel icon 5. Double-click the Netw...

Page 20 - Windows NT 3.5x Installation

- 19 - (Or type the path name whereever you place the driver programs) 11. A dialog box will appear to adjust the driver's settings. The resources assignment to the adapter must be unique in the system. 12. Press OK when all setting are completed. 13. Press Close to complete network setting Windows ...

Abocom FE2000 - Manual

Table of Contents:

Summary

Other Abocom Models