3Com NETBuilder II - Manual
3Com NETBuilder II – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Before You Begin; NETBuilder II Base System Installation Guide; How to Use This Guide; If you are looking for:; screen display; Bold
- Page 4 – Special Messages; Keys
- Page 5 – Before Installing the HSSI Module; Observe appropriate ESD precautions.; Do not touch pins, leads, or solder connections on the board.; Inspect the HSSI module for shipping damage.
- Page 6 – Verify that you have received all the contents.; When you purchase the HSSI module, you receive the following:
- Page 7 – Installing the HSSI Module; Select an I/O slot in which to install the HSSI module.
- Page 8 – Insert the HSSI module into an uncovered I/O slot.; not
- Page 9 – Cabling the HSSI Module for Network Connection
- Page 10 – Internal Loopback test; Com Corporation NETBuilder II power-on; Hotswap; HSSI Interface: Self Tests passed - slot 1
- Page 11 – Troubleshooting Startup Problems; Symptom; HSSI Interface: Self Tests failed - slot X; Action; Maintaining the HSSI Module; Preventive Maintenance; NETBuilder II Base System Installation
- Page 12 – Replacing the HSSI Module; To replace the module, follow these steps to remove the HSSI module:; Use both hands to grasp the board and gently pull it from the slot.
- Page 13 – LEDs; LED
- Page 14 – Connectors
- Page 15 – Type 3 to access the MAC address of the HSSI module.
- Page 17 – Automated Fax Service; On-line Technical Services; Com Product Information Service
- Page 18 – This private BBS, called CardBoard; , contains patches and drivers for 3Com adapter products,; Com Documentation on CD-ROM; Europe and Africa
- Page 19 – Before Contacting Your Network Supplier
- Page 20 – Additional 3Com Support Services
- Page 21 – Factory repair service; Equipment Warranties and Repair Services; Attach a reference number to equipment that is under warranty.
- Page 22 – Unit or board serial number (for warranty repairs only)
NETBuilder II
®
HSSI Module
Installation Guide
A member of the NETBuilder
®
family
For 3Com User Group Information
1-800-NET-3Com
or your local 3Com office
Manual Part No. 09-0489-000
Published January, 1994. Printed in the U.S.A.
THE
PRESIDENT S
ENVIRONMENT
CONSERVATION
CHALLENGE
AWARD
AND
1992
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
v Before You Begin This guide describes how to install, cable, maintain, and troubleshoot the High-Speed Serial Interface (HSSI) module for the NETBuilder II ® base system. The information in this guide applies to the NETBuilder II 4-slot chassis and the NETBuilder II 8-slot chassis. For more inform...
vi Special Messages A special format indicates notes, cautions, and warnings. These messages are defined as follows. NOTE: Notes call attention to important features or instructions. CAUTION: Cautions contain directions that you must follow to avoid immediate system damage or loss of data. WARNING: ...
Chapter 1Installation This chapter describes how to install the HSSI module into the NETBuilder II ® base system. The HSSI module provides a single serial interface for a WAN connection in the NETBuilder II base system. It supports transmission rates up to OC1, including E3, T3, and sub-rates. NOTE:...
