Page 3 - PROPER VENTING REGULATIONS
WARRANTY WARRANTY PROPER VENTING REGULATIONS Please verify with your local, city, and state regulations on the proper venting method for your hood. Many agencies have CFM rating specifications for your hood, as well. You may have to purchase additional items on your own to vent the hood in accor-dan...
Page 4 - DISCLAIMER
DISCLAIMER Carefully inspect all items for damages before accepting delivery. Customer should note any damages on the freight bill or express receipt. Request the name and signature of the carrier’s agent and keep a copy to support your claim. Upon acceptance of items, owner assumes responsibility f...
Page 5 - TABLE OF CONTENTS; TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1 Gener al Safet y IMPORTANT SAFETY INSTRUCTIONS 1 WALL RANGE HOOD INSTALLATION 4 WALL CROWN MOLDING INSTALLATION 9 DESIGNER WALL RANGE HOOD INSTALLATION 10 WALL CROWNSOUND ® INSTALLATION 15 ISLAND RANGE HOOD INSTALLATION 17 DESIGNER ISLAND RANGE HOOD INSTALLATION 21 ISLAND CROWNSOUND ® INSTALLATION...
Page 6 - wiring or other hidden utilities.; SAFETY INSTRUCTIONS; and meet industry standards and regulations.
3 2 Gener al Safet y Gener al Safet y SAFETY INSTRUCTIONS • Ducted fans MUST ALWAYS be vented to the outdoors. At the point where the duct work ends, add an external damper to prevent air from entering the home when the hood is not in use. This also prevents small animals and rain water from enterin...
Page 7 - WALL HOOD INSTALLATION; WALL HOOD INSTALLATION; Main Hood with All Lights and; all Hood Installation
5 4 W all Hood Installation WALL HOOD INSTALLATION Installation Tutorial Video WALL HOOD INSTALLATION A B C D 6 E F A B C D E F 1. Main Hood with All Lights and Button Banks Pre-Installed 2. Adjustable Stainless Steel Chimney Cover 3. Transition Piece (for 6” or 8”) 4. Baffle Filters5. Flexible Duct...
Page 8 - the heads out 1⁄4 ̋ to mount the hood.; ” can be found at the local hardware store.
7 6 W all Hood Installation W all Hood Installation The recommended height to install your hood is 30˝ minimum and 36˝ maximum above the cooktop. For Outdoor (304 Series) hood installation, the unit must be installed at a minimum of 36˝ and a maximum of 42” above the grill. 1. Find the center of the...
Page 9 - Figure 6; Slide crown molding onto crown bracket and secure into place.; WALL CROWN MOLDING INSTALLATION; Scan Me
9 8 W all Hood Installation W all Cr own Mold ing Installation WALL HOOD INSTALLATION 8. Install the two part chimneys on top of the hood. Slide the inside section up until the vertical vent slots are visible, attach top portion to mounting bracket with screws. Secure lower chimney portion to the ho...
Page 10 - PARTS SUPPLIED; DESIGNER WALL HOOD INSTALLATION
11 10 Designer W all Hood Installation Designer W all Hood Installation DESIGNER WALL HOOD INSTALLATION Installation Tutorial Video A B C D 6 E F Please unpack your range hood when it is delivered and inspect to ensure all parts are included. PARTS SUPPLIED NOTE: Wall range hoods with single motors ...
Page 11 - place. Attach the ducting to the range hood.
13 12 Designer W all Hood Installation Designer W all Hood Installation DESIGNER WALL HOOD INSTALLATION The recommended height to install your hood is 30˝ minimum and 36˝ maximum above the cooktop. For Outdoor (304 Series) hood installation, the unit must be installed at a minimum of 36˝ and a maxim...
Page 12 - WALL CROWNSOUND; ELECTRIC POWER RATING
15 14 W all Cr ownSound ® Installation Designer W all Hood Installation DESIGNER WALL HOOD INSTALLATION 8. Find the center of the wall where you are installing the hood. Make sure there is sufficient bracing to hold the weight of the hood. Mark your center line and measure out from the center to fin...
Page 13 - Figure 3; ISLAND HOOD INSTALLATION
17 16 Island Hood Installation W all Cr ownSound ® Installation WALL CROWNSOUND ® INSTALLATION 3. Extend the chimney up to the transformer. Slide the crown molding onto the crown bracket and secure into place. The crown should cover the gap. Ensure that it installs properly and is level. Figure 3 4....
Page 15 - the top of the chimney sections.; DESIGNER ISLAND HOOD INSTALLATION
21 20 Designer Island Hood Installation Island Hood Installation ISLAND HOOD INSTALLATION 1. Slide chimney pieces over the angle iron on the hood. Pull the electrical plug to the top of the chimney sections. Figure 4 2. Lift the hood to attach the angle iron to the ceiling bracket. Use screws provid...
Page 17 - ISLAND CROWNSOUND
25 24 Island Cr ownSound ® d Installation Designer Island Hood Installation DESIGNER ISLAND HOOD INSTALLATION 6. Slide chimney pieces over the angle iron on the hood. Pull the electrical plug to the top of the chimney sections. Figure 4 7. Lift the hood to attach the angle iron to the ceiling bracke...
Page 18 - UNDER CABINET INSTALLATION
27 26 Under Cabinet Installation Island Cr ownSound ® Installation 3. Extend the chimney up to the transformer. Slide the crown molding onto the crown bracket and secure into place. The crown should cover the gap. Ensure that it installs properly and is level. Figure 3 4. Open the phone’s Bluetooth ...
Page 19 - RECIRCULATING KIT; Under Cabinet Installation; PREPARATION
29 28 Screw Screw Screw Under Cabinet Installation RECIRCULATING KIT 1. Open package, locate all necessary hardware. Included should be 4 screws with 4 washers. 2. Line up the recirculating kit with the top of the range hood. 3. Secure the recirculating kit with the provided screws. Once secure, beg...
Page 21 - Figure 1; the range hood insert.; Remote Blower Installation; INSERT INSTALLATION; The remote blower must be kept; REMOTE BLOWER INSTALLATION; Figure 2
33 32 Figure 1 Screw When installing a range hood insert, it is recommended to install the unit at a minimum of 30˝ from the cooktop. For outdoor range hood inserts it is recommended to install the unit at a minimum of 36˝ and a maximum of 42” from the grill top. Use rigid ducting wherever possible....
Page 22 - T85 Remote Blower—Single Motor; Unit Connection Cord
35 34 Button/Contr ol Panel Oper ation Remote Blower Installation The Remote Blower is designed for our Remote Range Hoods. This unit is installed remotely in the interior of your home. This provides venting, but with reduced noise. T85 Remote Blower—Single Motor (This Blower must be used with Remot...
Page 23 - Installation; CHANGING PARTS; HOW TO REPLACE THE CIRCUIT BOARD
37 36 Replacing th e Cir cuit Boar d Changing th e But ton P anel CHANGING PARTS Installation Tutorial Video ground ground HOW TO CHANGE OUT THE BUTTON PANEL 1. Remove baffle/aluminum filters. 2. Locate back of button panel. 3. Remove screws from each side of the button panel. 4. Disconnect button p...
Page 24 - REPLACING THE LIGHT BULBS IN YOUR RANGE HOOD; PROFESSIONAL SERIES BAFFLE FILTER CHANGE
39 38 Changing Baffle Filter s Replacing Light Bulbs CHANGING PARTS REPLACING THE LIGHT BULBS IN YOUR RANGE HOOD 1. Remove baffles. 2. Squeeze the old LED light casting out until it falls out of the socket.3. Disconnect the plug wires from the light wire.4. Reconnect the LED plug into the light wire...
Page 25 - BAFFLE FILTER; there will be two capacitors.; Release
41 40 Changing th e Capacitor Changing Baffle Filter s BAFFLE FILTER The baffle filter is equipped with a knob. To remove from the hood, pull back toward the wall and down. CHANGING PARTS CHANGE/REPLACE CAPACITOR: 1. Remove screws from the circuit board cover. 2. Remove screws from compactor. 3. Rem...
Page 26 - Filter Support Screws; the unit or switch the electrical breaker to the off position.; Slide into place
43 42 Replacing Char coal Filter s Changing th e Grease Cup CHANGING PARTS Filter Support Screws REPLACE OR CHANGE CHARCOAL FILTERS: It is recommended to direct vent the hood whenever possible. If your situation does not allow for a direct vent install, carbon filters are available to recirculate th...
Page 27 - REPLACE OR CHANGE TRANSFORMER:; SINGLE MOTOR ELECTRICAL DIAGRAM
45 44 Single Motor Electrical Diagr am Changing th e T ransformer REPLACE OR CHANGE TRANSFORMER: 1. Remove the screws from the transformer.2. Remove the two connections to the lights.3. Remove the two wired connections from the circuit board (you must remove the circuit board cover). 4. Install the ...
Page 28 - The height of your range hood should be between 30 ̋ to 36 ̋ above your; TROUBLESHOOTING
47 46 Double Motor Electrical Diagr am Troublesh ooting CHANGING PARTS DUAL MOTOR ELECTRICAL DIAGRAM ground ground ground Where are ZLINE products manufactured? All ZLINE products are manufactured in ZLINE facilities overseas, including: Germany, Italy, and China. Are ZLINE range hoods considered ty...
Page 29 - No, unfinished hoods are only compatible with paint.; Our hoods have a squirrel cage motor.
49 48 Tr oublesh ooting Troublesh ooting How loud is the range hood? A sone is measure of loudness, the higher the sone rating, the louder the sound of the hood. The sound of one sone is comparable to that of a quiet refrigerator. Keep in mind that other factors such as the size of the blowers can a...
Page 30 - Only 1 device can sync at a time.; circuit breaker is off or the fuse has blown.
51 50 Troublesh ooting Tr oublesh ooting TROUBLESHOOTING My hood is operating, but the air is moving slower than normal. Check the filter for buildup and clean or replace it if needed. If the difficulty still persists, check for obstructions in the ductwork. A common obstruction is buildup in the ro...
Page 31 - My range hood is not pulling.; Noisy Motor
53 52 Troublesh ooting Tr oublesh ooting TROUBLESHOOTING My range hood is not pulling. • Was the unit plugged in and was the fan checked before installation?• What distance is the hood mounted above the cook top? • Indoor (30”-36”), outdoor (36”-40”) • Is the range hood width the correct size for th...
Page 32 - Model Numbers; MOUNTING SPECIFICATIONS
55 54 433 432 MOUNTING SPECIFICATIONS Model Numbers A B C D 432-30 432-36 432-42 432-48 8 " A B C D 26 1116 " 35 3 4 " 19 116 " 8 " 20 1116 " 29 3 4 " 19 116 " 8 " 32 1116 " 41 3 4 " 19 116 " 8 " 38 1116 " 47 3 4 " 19 116 " Model Number...
Page 46 - BSKBN
83 82 BSKBN BS655N Model Numbers A B C D BS655N-30 BS655N-36 BS655N-42 BS655N-48 8 " 6 " 8 " 8 " B C D A 17 1116 " 9 1116 " 13 516 " 17 1116 " 9 1116 " 13 516 " 17 1116 " 9 1116 " 13 516 " 17 1116 " 9 1116 " 13 516 " MOUNTING SPECIFICAT...
Page 48 - KE
87 86 KE KB2 B A C D Model Numbers A B C D KB2-30 KB2-36 KB2-42 KB2-48 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " 13 3 8 "13 3 8 "13 3 8 "13 3 8 " MOUNTING SPECIFICATIONS A Model Numbers A B C D ...
Page 49 - KF
89 88 KL2 KF , KF1 , & KF2 Model Numbers A B C D KF-36 KF1-30 12 " 6 " 6 " B C D A 13 5 8 " 8 12 " 10 12 " KF1-36 7 116 " 9 18 " KF2-30 6 " 8 12 " 10 12 " KF2-36 15916 " 6 " 13 5 8 " 8 12 " 10 12 " 6 " 8 12 " 10 12 " 159...
Page 50 - KN
91 90 KN KL3 MOUNTING SPECIFICATIONS Model Numbers A B C D KL3-30 KL3-36 KL3-42 KL3-48 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " 7 1 16 " 9 1 8 " 6 " B C D A 12 3 4 "12 3 4 "12 3 4 "12 3 4 " MOUNTING SPECIFICATIONS ...
Page 53 - Installation Guide and User Manual
Installation Guide and User Manual 1-614-777-5004 1.2.1 www.zlinekitchen.com
