Zenoah SRTZ2601F - Manual - manualsarea.com

Page 2 - EC DECLARATION OF COMFORMITY; EXPLANATION OF SYMBOLS AND SAFETY WARNINGS; APPROVAL NUMBER OF CE EXHAUST EMISSION REGULATION; RISK OF DAMAGING HEARING; MODEL

GB-2 SRTZ2601F EC DECLARATION OF COMFORMITY We, ZENOAH CO., LTD. 1-9, Minamidai, Kawagoe, Saitama, Japan declare in sole responsibility that the following products referred to in this declaration conform with DIRECTIVE 89/336/EEC, 98/37/EC, 2000/14/EC, 97/68/EC, 2002/88/EC, 2002/44/EC, prEN774[2001]...

Page 3 - Information; SAFETY FIRST; WARNINGS IN THE MANUAL; Contents

GB-3 G B SRTZ2601F Information This machine is equipped with an Overload Cancellation Mechanism.When the cutting blades have got into metal wires or twigs difficult to cut, the mechanism works as a shock absorber,and protects the gears and the blades from severe reaction which could give damage to t...

Page 4 - Model

GB-4 SRTZ2601F Model SRTZ2601F Overall size (LxWxH) mm 1734 x 338 x 254 Dry weight * kg 6.4 Engine Type Air-cooled 2-stroke gasoline Model Zenoah GZ25N Max output rpm 1.2Hp (0.9kW) at 7500min -1 Idle speed rpm 3000 ± 200min -1 Displacement cm 3 25.4 Fuel Mixture (Gasoline 50 : Oil 1) (when using ZEN...

Page 5 - WORKING CONDITION; protector; WORKING CIRCUMSTANCE; If you don’t observe the working; “USING THE PRODUCT”; For safe operation

GB-5 G B SRTZ2601F 1. Read this manual carefully until you completely understand andfollow all safety and operatinginstructions. 2. Keep this manual handy so that you may refer to it later when-ever any questions arise. Alsonote, if you have any questionsw h i c h c a n n o t b e a n s w e re dherei...

Page 6 - IMPORTANT

GB-6 SRTZ2601F WARNING Never place the throttle into thehigh-speed position when startingthe engine. 3. After starting the engine, check to make sure that the cutting at-tachment stops moving when thethrottle is moved fully back to itsoriginal position. If it continues tomove even after the throttle...

Page 9 - Pay attention to agitation.; WARNING

GB-9 G B SRTZ2601F ■ RECOMMENDED MIXING RATIO GASOLINE 50 : OIL 1 (when using ZENOAH genuine oil) • Exhaust emission are controlled by the funda-mental engine parameters and components (eq.,carburation, ignition timing and port timing) with-out addition of any major hardware or the intro-duction of ...

Page 12 - MAINTENANCE CHART

GB-12 SRTZ2601F 9. Maintenance Every Every Every 25 50 100 System/components Procedure Before hours hours hours Note use after after after fuel leaks, fuel spillage wipe out ✔ fuel tank, air filter, fuel filter inspect/clean ✔ ✔ replace, if necessary see adjusting replace carburetor idle adjusting s...

Page 14 - • The muffler is equipped with a spark arrester to pre-; • Never touch the cylinder, muffler, or spark plugs; • If waste gets stuck and causes blockage around the

GB-14 SRTZ2601F MUFFLER WARNING • Inspect periodically, the muffler for loose fasten- ers, any damage or corrosion. If any sign of ex-haust leakage is found, stop using the machineand have it repaired immediately. • Note that failing to do so may result in the engine catching on fire. SPARK ARRESTER...

Page 15 - Limited warranty; THE WARRANTY DOES NOT APPLY TO; THOSE UNITS; THIS WARRANTY DOES NOT COVER; INCLUDING THOSE OF MER-; ARE LIMITED; Troubleshooting guide

GB-15 G B SRTZ2601F Limited warranty Should any failure occur on the product under normal oper-ating conditions within the applicable warranty period, thefailed part will be replaced or repaired free of charge by aZENOAH authorized dealer. WARRANTY PERIOD: 1 year (6 months if used profession- ally, ...

Zenoah SRTZ2601F - Manual

Table of Contents:

Summary

Other Zenoah Models