Zenith Pumps - Manual
Zenith Pumps – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Materials Of Construction Diagram And Chart; Dimensional Data Chart; Dimensional Diagram
- Page 7 – Disassembly
- Page 9 – Reassembly
- Page 10 – Bolt Torque
- Page 11 – Troubleshooting; Trouble
Zenith
®
Pumps
Installation,
Care and
Maintenance
Zenith
Polymer
Extrusion
Gear Pumps
PEP-II Series
Gear Pumps
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
PEP-II Pump0.16-3 cc/rev ITEM QTY PART MATERIAL 1 1 FRONT PLATE TOOL STEEL 2 1 CENTER PLATE TOOL STEEL 3 1 REAR PLATE TOOL STEEL 4 1 DRIVE SHAFT TOOL STEEL 5 1 ARBOR TOOL STEEL 6 2 METERING GEAR TOOL STEEL 8 2 KEY, GEAR 9 2 BEARING TOOL STEEL 10 2 BEARING TOOL STEEL 11 1 RHEOSEAL STAINLESS 13 1 SEAL...
Cleaning,Inspection,Repair andService 7 Disassembly After removal from the system, the assem-bled pump can be cleaned by placing itin a suitable furnace (i.e. vacuum oven,fluidized bed, etc.) and slowly increasingthe temperature to 800-850° F in no lessthan two hours. Special care should betaken to ...
Reassembly 9 These instructions should be thoroughlyread and understood before startingreassembly. General instructions that should be observed to ensure correct reassembly of the pump are as follows: • Using a solvent such as trichloroethane or chloroethene Nu, clean all parts that are to be used i...
