YARD FORCE YF22-2N1 - User Manual
YARD FORCE YF22-2N1 Lawnmower – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – OPERATION
- Page 3 – MOWING; first cut of the season or in drought conditions.
- Page 4 – MAINTENANCE AND STORAGE; until the blade has come to a stop.; CLEANING; GENERAL CLEANING; Do not tilt the lawn mower by more than 90 degrees.; MAINTENANCE OF THE SPARK PLUG
- Page 5 – MAINTENANCE OF THE AIR FILTER; Never run the engine without the air filter element installed.; CHECK AND ADD THE ENGINE OIL
- Page 6 – If the blade is cracked or damaged, replace it with a new one.; STORING THE LAWN MOWER FOR SHORT PERIODS
- Page 7 – MAINTENANCE SCHEDULE; 2 hours of use; TRANSPORTING THE LAWN MOWER
14
Hotline: 1-866-902-9690
OPERATION
START AND STOP THE ENGINE
WARNING:
the blade begins to rotate as soon as the engine is started.
NOTE:
Do not operate the lawn mower in enclosed or poorly-ventilated areas as the exhaust
gas contains toxic substances.
Keep hands, feet, hair and clothing away from the moving parts of the machine. The exhaust and
other parts of the machine will become hot during use.
Make sure that the blade is securely fastened before starting the engine.
NOTE:
to start the engine, make sure that the spark plug cover is connected to the plug and the
machine is filled with sufficient oil and gas.
TO START THE ENGINE
1. When starting a cold engine, press down the primer fully 3-5 times (see Fig. 12).
WARNING!
Too many presses on primer may cause engine flooding. When starting a warm engine,
the primer does not need to be used. If the engine stops due to a lack of gas, refill then press the
primer 3-5 times.
2. Stand behind the mower. Pull the Engine On/Off Control Bar toward upper handle with one hand and
place the other hand on the starter handle.
3. Pull the starter handle out approximately 4" to 6" (10 to 15 cm) until you feel a resistance and then start
the engine with a sharp pull (see Fig. 13).
NOTE:
If the engine fails to start after three pulls, repeat the process.
Fig.12
Fig.13
primer
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
15 Hotline: 1-866-902-9690 4. Once the engine is running, put the starter rope into the rope guide (see Fig. 14). TO STOP THE ENGINE As shown in Fig. 15 Release the Engine On/Off Control Bar. It will return to its initial position and the engine will automatically switch off. TO CLEAN A FLOODED ENGI...
16 Hotline: 1-866-902-9690 OPERATION (2) Use the spark plug socket wrench (not supplied) to remove the spark plug (see Fig. 17). (3) After drying, tighten the spark plug. NOTE: Install the spark plug carefully by hand to avoid cross-threading. After the plug is seated, tighten 1/8 to 1/4 turn with t...
17 Hotline: 1-866-902-9690 MAINTENANCE AND STORAGE WARNING: Before performing any maintenance or cleaning work, switch off the engine and wait until the blade has come to a stop. CLEANING GENERAL CLEANING The lawn mower should be cleaned thoroughly every time after it has been used. Always clean you...
