Yale YRL226-ZW2-BSP - User Manual

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 5 x4 Install Latch Strike Plate and Right Hand Installation Shown 2-3/8" through bolt posts, default 2-3/4" through bolt posts, optional PULL Outside of Door Frame 2-3/8" (60mm) or 2-3/4" (70mm) Backset 3 O Note: Adjustment is based on bac...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 11 9 10 Install Outside Lever Install Inside Lever Inside of Right Hand Door Press pin while installing lever so lock is not damaged. Outside of Right Hand Door YRL226 Cylinder Shown Press pin while installing lever so lock is not damaged.

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 12 Test Thumbturn Operation with Door Open Outside of Right Hand Door Test thumbturn and both levers in locked and unlocked positions. If operation fails, check installation beginning with Step 4 and refer to Hardware Troubleshooting. Outside of Right Han...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 13 Test Key Operation with Door Open (YRL226) If key operation test fails, check installation beginning with Step 8. Outside of Right Hand Door Outside of Right Hand Door

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 15 12 Inside of Right Hand Door Install Batteries and Cover Congratulations, you've installed the Yale Assure Lever ® Touchscreen (YRL226) or Key-Free Touchscreen (YRL256)! Using Your Lock instructions will help you customize your lock. "Welcome to Ya...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 16 Test Touchscreen Operation with Door Open A Master Entry Code must be created upon installation or after resetting the lock to factory default. Programming and use of lock is not possible until this step has been successfully completed. See Using Your ...

17 P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY When resetting the lock, all Entry Codes, including the Master Entry Code*, are deleted. All programming features are reset to original default settings. See “Setting Definitions”. 1. Remove the battery cover and batteries. 2. Remove the inside lock to ...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 18 Cycle lock in both the locked and unlocked positions. If problems are found: Tailpiece and spindle will not mate and fit into the inside lock a. Make sure that your door is between 1-3/8" and 1-3/4" thickb. Make sure that the square shaped spind...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 19 Setting Definitions *The Master Entry Code must be created prior to any other programming of the lock. Creation required* Settings Default Setting Master Entry Code Definition The Master Entry Code is used for programming and for feature settings. It mus...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 20 While Yale® has included several features to prevent lockout (9-Volt battery jumper, low battery warnings), it is still possible for a lockout situation to occur. Because the YRL256 does not have a key, Yale® recommends using YRL256 in an environment w...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 21 Creating Master Entry Code The Master Entry Code is used to change lock settings. A security best practice is to set your Master Entry Code with 6 or more digits and create a separate code that is used daily to lock and unlock the door. Enter 4-8digit ...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 22 Creating Entry Codes Master Entry Code must be created first.*Max Entry Codes = 250 with Smart Module; 25 without. PressPress Press Press Press(code flashes) Press Enter MasterEntry Code Press "Menu Mode, enter number, press the gear key to continue....

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 23 Deleting Entry Codes Enter MasterEntry Code "Menu Mode, enter number, press the gear key to continue." Press Press Press Press Press To delete all Entry Codes(Does not delete Master Entry Code): Press Enter Deleting one Entry Code: Enter 4-8 di...

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 24 Duplicate if necessary User Name: Entry Code Code Chart Homeowner Babysitter Unlocking Door with Entry Codes Master: Entry Code Management Press Enter Entry Code

P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY 25 Customizing Lock Using Settings Menu *The Master Entry Code must be created prior to any other programming of the lock.**Network Module Setting function appears only with Yale Smart module installed. Here is an example of how to set Auto Lock to 30 sec...

26 P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY Troubleshooting Symptom Suggested Action Lock does not respond – door is open and accessible. • • • • • • Lock chimes indicating code acceptance, but door will not open. • • Lock operates to allow access, but will not automatically re-lock. • • • Entry...

27 P/N YRL-TS-MNL-0018 Rev C Part of ASSA ABLOY FCC: Class B Equipment This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a r...