Whirlpool WRMF7736PZ - Manual
Whirlpool WRMF7736PZ – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNING; Bottom Mount Refrigerator
- Page 3 – AVERTISSEMENT; Réfrigérateur à congélateur inférieur
- Page 5 – Refrigerador de montaje inferior
- Page 6 – ADVERTENCIA
1
ELECTRICAL REQUIREMENTS
Electrical:
A 115 V, 60 Hz AC only, 15 A or 20 A fused, grounded electrical
supply is required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do
not use an extension cord.
NOTE:
Before performing any type of installation, cleaning, or removing a light
bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the electrical source and
reset the control (Thermostat, Refrigerator or Freezer Control depending on the
model) to the desired setting. See “Using the Controls.”
Water:
A cold water supply with water pressure between 35 psi and 120 psi
(241 kPa and 827 kPa) is required to operate ice maker and water dispenser. If
you have questions about your water pressure, call a licensed, qualified plumber.
IMPORTANT:
The pressure of the water coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between
35 psi and 120 psi (241 kPa and 827 kPa).
Reverse Osmosis Water Supply:
If a reverse osmosis water filtration system is
connected to your cold water supply, the water pressure to the reverse osmosis
system needs to be a minimum of 40 psi to 60 psi (276 kPa to 414 kPa).
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Bottom Mount Refrigerator
Model Size
Height Overall
“A”
Height - Top of
Cabinet
“B”
Depth - Door
Open 90°
“C”
Depth - Drawer
Open
“D”
Depth - With
Handles
“E”
Depth - Without
Handles
“F”
Depth - Cabinet
Only
“G”
Width - Cabinet
“H”
Width - Door
Open 90°
“I”
WRX988SIB,
WRMF7736P
70
1
/
8
" (1781 mm)
68
5
/
8
" (1743 mm)
48" (1219 mm)
47
5
/
8
" (1210 mm) 35
11
/
16
" (906 mm)
33
3
/
16
" (843 mm)
28
15
/
16
" (735 mm)
35
11
/
16
" (906 mm)
38
3
/
16
" (970 mm)
WRX986SIH
70
1
/
8
" (1781 mm)
68
3
/
4
" (1746 mm)
48
5
/
8
" (1235 mm)
47
5
/
8
" (1210 mm) 36
3
/
8
" (924 mm)
33
3
/
4
" (847 mm)
29" (737 mm)
35
3
/
4
" (908 mm)
38
3
/
16
" (970 mm)
Top of
Cabinet
Including
Handle
Cabinet
Not Including
Handle
Overall
Height
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 LOCATION REQUIREMENTS To ensure proper ventilation for your refrigerator, it is recommended to allow a 1/2" (1.27 cm) space on each side and at the refrigerator top. Allow at least 1" (2.54 cm) between back of cabinet and the wall (consider the condenser as back in case is present). If you...
3 Taille du modèle Hauteur totale « A » Hauteur jusqu’au sommet de la caisse « B » Profondeur avec porte ouverte à 90° « C » Profondeur avec le tiroir ouvert « D » Profondeur avec poignées « E » Profondeur sans les poignées « F » Profondeur de la caisse uniquement « G » Largeur de la caisse « H » La...
5 REQUISITOS ELÉCTRICOS Eléctrico: Se requiere un suministro eléctrico de 115 V, 60 Hz CA solamente, con fusibles de 15 A o 20 A, debidamente conectado a tierra. Se recomienda utilizar un circuito de alimentación separado y de uso exclusivo para el refrigerador. Use un tomacorriente que no se pueda ...
