Whirlpool ADG 6500 - Manual
A user manual for the Whirlpool ADG 6500 dishwasher covers essential operational and maintenance topics. The guide highlights control panel functions, wash program configurations, detergent usage, and water hardness adjustments to optimize performance. Daily checks–such as rinse aid and detergent levels–are emphasized alongside loading techniques, filter cleaning, and troubleshooting common issues like cycle failures or cleaning inefficiencies. Safety and compliance details, including appliance disconnection and waste disposal, are also addressed.
Table of Contents:
- Page 1 – Control Panel and Program Reference
- Page 2 – Water Hardness and Salt Reservoir Setup
- Page 3 – Daily Maintenance Procedures
- Page 4 – Dish Loading Instructions
- Page 5 – Cycle Management and Filter Cleaning
- Page 6 – Troubleshooting Common Faults
- Page 7 – Specific Troubleshooting Solutions
- Page 8 – Malfunction Procedures and Disposal
GB -1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher (1
minute process).
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks.
To resume the cycle push the Start button and
close the door within 3 seconds.
1)
Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2)
Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
“[email protected]”.
Table of programs
Deter-
gent
Consumption
P
Programs
Loading instructions
Litres kWh Minutes
1)
1
Pre-Wash
cold
Crockery to be washed later.
—
5.0
0.02
10
2
Quickwash 40°C
Lightly soiled crockery, with no
dried-on food.
X
13.0
0.70
30
3
Eco
2)
50°C
Normally soiled crockery.
Energy-saving program.
X
15.0
1.05
165
4
Intensive
70°C
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X
15.0
1.50
140
5
Half Load
50°C
Ideal for washing a half load of
lightly or normally soiled crockery.
X
13.0
1.00
130
5019 396 03515
ADG 6500
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- Whirlpool
- Model
- ADG 6500
- Document type
- Manual
- Language(s)
- English
- Pages
- 8
- File size
- 1.6 MB
- Format
Summary
Guide to using control panel buttons, available wash programs with settings, detergent requirements, energy consumption, and inactivity timeout.
Instructions for setting water hardness, filling the salt reservoir, accessing a water hardness chart, and daily performance checks.
Instructions for daily maintenance, including adjusting rinse aid dosage, adding detergent types, checking rinse aid levels, and interpreting indicator lights.
