Wharfedale EZ-M 10X2 - Manual

Page 2 - Table of Contents; Page

Table of Contents Page 1 Introduction / Features / Back Panel diagram 2 Important Safety & Warranty Information 3 Detailed Features of the EZ-m 10x2 – Mic/Line Input Channel 4 Mono Mic/Line Channel - Low Impedance (Low Z) MIC Input - LINE IN - GAIN Control - CLIP LED 5 - Mono Channel EQ Section ...

Page 3 - Introduction; FEATURES

Introduction Thank you for purchasing a Wharfedale Pro EZ-m mini-mixer . The Wharfedale Pro EZ-m Series mixers are designed for ease of use and quality audio performance. Please read this manual completely to ensure proper understanding of the features and operation of your mixer. FEATURES EZ-m 10x2...

Page 4 - Important Safety & Warranty Information

Important Safety & Warranty Information 1. Power Supply This EZ-m Series mini-mixer is supplied with an external power supply unit. Use only the power supply provided with your mixer. Use of any other power supply could cause damage to the mixer and other equipment. Connect the power supply to t...

Page 5 - DETAILED FEATURES OF THE EZ-m 10x2; Mono Mic / Line Input Channel

DETAILED FEATURES OF THE EZ-m 10x2 Mono Mic / Line Input Channel 3

Page 6 - Control; CLIP; LED

Low Impedance (Low Z) MIC Input The low noise, high headroom “Low Z” MIC input is for use with balanced, low impedance dynamic microphones. NOTE: Condenser microphones will not work on this mixer. LINE IN This ¼” Tip, Ring, Sleeve (TRS) jack is designed to be connected with (-10 to +4dBu) balanced o...

Page 7 - EQ Section; Pan and Level; Pan Control:

EQ Section Channel 1 on the EZ-m 10x2 mixer features a two band Equalization (” EQ ”) section. Each band is chosen from the prime frequencies for most musical applications, and allows up to 15 decibels of boost (increase) or cut (decrease) of the signal in the tone range for which it controls. The H...

Page 8 - BALANCE Control; Stereo Channel Level Control

Stereo Channel Inputs Each of the stereo channels on the EZ-m 10x2 ( 2/3 and 4/5 ) feature two line level inputs with ¼” Tip/Ring/Sleeve (TRS) jacks for both balanced and unbalanced left and right input signals. These inputs can accommodate both stereo and mono inputs. When using a mono source, conn...

Page 9 - Master Section; POWER LED

Master Section The master section on the right side of the mixer controls the final gain stage of the mixed signals from the input channels. The MAIN MIX control allows for the adjustment of the overall output level of the EZ-m mixer. POWER LED & Signal Metering POWER LED This amber LED lights i...

Page 11 - CONNECTION WIRING DETAILS; Line Inputs; MAIN MIX Outputs

16 16 POWER Switch – On/Off This slide switch turns the unit on and off. Always power down the EZ-m when it is not in use. Be sure to turn off all system amplifiers or powered speakers before turning off the mixer. 17 AC Power Cable Connector The included power adaptor connects here. Use only the po...

Page 12 - SPECIFICATIONS

SPECIFICATIONS EZ-m mini-mixer 10X2 Specifications Maximum Output Level (1%T.H.D. @ 1kHz) +22dBu over 130mw (headphone) @ 32 ohms THD+N% <0.01% @ +15dBu Frequency Response 20Hz-20kHz +0/-1dB Hum and Noise -127dB Mic Pre Equivalent Input Noise '-90dBu Residual Noise Maximum Input Levels Mic In: '+...

Page 13 - BLOCK DIAGRAM