Westinghouse FG6RL - Manual

TECHNICAL
SPECIFICATIONS

The high efficiency downflow gas furnace may be installed
free standing in a utility room, or enclosed in an alcove or
closet. The extended flush jacket provides a pleasing
“appliance appearance.” Design certified by the Canadian
Standards Association (CSA). The product is truly designed
with the contractor and the consumer in mind.

FEATURES & BENEFITS

• Best warranty in the business -

– A lifetime warranty on the heat exchanger
– 8 Year Limited Parts and 5 Year Quality Pledge

• 100% fired and tested -

All units and each component

(both mechanical and electrical) are tested on the
manufacturing line.

• Best packaging in the industry -

Unique design assures

product will arrive to the homeowner dent free.

• Clean and quiet operation -

Due to the unique design of

in-shot burners, location of inducer, return air vents, and
use of insulation.

•

Fixed 30 second blower delay

at burner start-up assures

a warm duct temperature at furnace start-up. Adjustable
blower off settings (60, 120, 160 and 180 seconds).

•

Fixed 30 second post purge

increases life of heat

exchanger.

• SmartLite

TM

Control Board —

Provides extended life to

ignitors in furnaces using hot surface ignition technology.
Programmed to learn the heat-up characteristics of the
ignitor, then adapt the ignition time to the characteristics
of the furnace so the ignitor is energized appropriately.

•

Dependable, hot surface ignitor -

Innovative application

of an appliance type ignitor with a 20 year history of
reliability, assures no callbacks because of handling.

•

Color coded wire harness -

Designed to fit the

components, all with quick-connect fittings for ease of
service and replacement.

•

Tubular primary heat exchanger -

Heavy gauge

aluminized steel heat exchanger assures a long life.

•

Stainless steel secondary heat exchanger

assures long

life.

•

90-second fixed cooling cycle blower-off delay (TDR)

increases cooling performance when matched with a
NORDYNE coil.

•

Approved for direct vent furnace, category IV venting
system –

May be vertically or horizontally vented using

either a one-pipe or two-pipe system for maximum flexibility
in installation.

•

Fully insulated blower cabinet

for quiet operation.

•

Multi-speed direct drive blower -

Designed to give a

wide range of cooling capacities. 40VA transformer included.

•

LP convertible -

Simple burner orifice and regulator spring

change for ease of convertibility.

•

Diagnostic light flashes identify limit failure, pressure
switch failure and improper ground and polarization -

for easy troubleshooting.

•

Incorporates integrated control board

with connections

for electronic air cleaner, humidifier and twinning.

•

Factory installed drain system

for reliable performance.

•

Door design

enhances furnace appearance and uses

screw fasteners for great fit and accessibility.

•

3 amp fuse

protection against high and low voltage shorts;

protects transformer and control board.

•

Low voltage terminal board

for easy field wiring.

•

Components and Controls -

Designing quality into our

products means selecting manufacturers that have a
reputation for delivering high quality, dependable products.

FG6RL Series

High Efficiency / Direct Vent or Non Direct Vent

Condensing Downflow Gas Furnace

Induced Draft - 92.1 AFUE

Input 40,000 - 120,000 Btuh