Weed Eater 530087645 - Manual
Weed Eater 530087645 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SAFETY RULES; DANGER; OPERATOR SAFETY
- Page 4 – ASSEMBLY; CARTON CONTENTS
- Page 7 – STOPPING YOUR ENGINE
- Page 8 – USING YOUR UNIT
- Page 9 – REPLACING THE LINE
- Page 10 – SERVICE; CARBURETOR ADJUSTMENT; TROUBLESHOOTING TABLE
BC3100
R
Trademark
DANGER:
Read and follow all Safety Rules and Operating Instructions before
using this product. Failure to do so can result in serious injury.
ADVERTENCIA:
Lea el manual del operador y siga todas las advertencias e instruc-
ciones de seguridad. El no hacerlo puede resultar en lesiones graves.
AVERTISSEMENT:
Lire le manuel de l’utilisateur et bien respecter tous les avertisse-
ments et toutes les instructions de sécurité. Tout défaut de le faire
pourrait entraîner des blessures graves.
Operator ’s Manual
Manual del Operador
Manuel de l’utilisateur
EN
GLISH
ESP
A
Ñ
O
L
FRANÇAIS
Electrolux Home Products, Augusta, GA 30907
WCI Outdoor Products, Inc.
530087645
8/31/00
Please do not return unit to retailer.
Por favor, no devuelva el aparato al lugar de compra.
Veuillez ne pas retourner l’outil au détaillant.
1-800-554-6723
www.weedeater.com
UL
R
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 SAFETY RULES DANGER : This power tool can be dangerous! This unit can cause serious injury including amputation or blindness to the opera- tor and others. The warnings and safety instruc- tions in this manual must be followed to provide reasonable safety and efficiency in using the unit. The opera...
4 ASSEMBLY CARTON CONTENTS Check carton contents for the following: S Brushcutter S tube mounting screws (2) S tube mounting nuts (2) S control handle mounting screw (1) S blade shield screws (4) S handlebar screws (2) S cupped washer (1) S large nut for installing blade (1) S long hex key wrench (1...
7 the raised part of the retaining washer is facing the gearbox, and the raised area fits into the hole in the center of the blade. S Slide the blade and retaining washer onto the shaft of the gearbox. S Now place the cupped washer onto the shaft. Make sure the cupped side of the washer is toward th...
