Weber Indoor Fireplace - Manual
Weber Indoor Fireplace – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Assembly; Tools needed; Install Steel Handles; Figure 1; Check Package Contents; Parts
- Page 3 – Step 4; Install Three Legs; Figure 3; Install Wood Handles; Install handles as shown in Figure 2.; Figure 2; Install Heat Deflector and Fourth Leg; Figure 4
- Page 4 – Assemble Lower Support Ring; Assemble lower support ring as shown in Figure 6.; Figure 6; Assemble Upper Support Ring; Assemble uprights as shown in Figure 5.; Figure 5; Step 8; Final Assembly; Figure 7
®
®
DANGER
Please read the following warnings carefully before using your FirePlace. Failure to follow these
warnings may result in serious bodily injury or death, or in a fire causing damage to property.
WARNINGS
䡵
The Weber FirePlace is designed solely for
outdoor use. Indoor use can be lethal.
䡵
Use only on noncombustible surfaces,
such as brick, flagstone, concrete, etc.
Do not use on a wooden deck.
䡵
Keep away from flammable materials,
buildings and vehicles when in use.
䡵
Exercise the same care that you would
with an open campfire.
䡵
Your Weber FirePlace is not to be used by
children.
䡵
Keep away from flammable fluids such as
gasoline, charcoal lighter fluid and
alcohol, etc.
䡵
Keep children and pets away from the
FirePlace when in use.
䡵
Never wear loose-fitting or flammable
clothing (such as nylon) when in use.
䡵
Do not overload. Before starting the fire
make sure the lid is capable of closing.
Overloading can be dangerous if the lid
cannot extinguish the fire.
䡵
Do not use soft woods, like pine or cedar.
Soft woods may "pop" and throw sparks.
䡵
Do not burn leaves, paper, plywood or
trash in the Weber FirePlace.
䡵
Do not use volatile fluids, such as
gasoline, charcoal lighter fluid or alcohol,
to light or relight fires.
䡵
Use only sturdy, long-handled fireplace
equipment, when adding or moving logs.
䡵
Do not attempt to move the FirePlace when
in use or hot.
䡵
Use barbecue mitts when handling,
because surfaces will be hot when in use.
䡵
Fill the Weber FirePlace bottom with
approximately two pounds of sand before
use. This helps to insulate the bottom of
the FirePlace.
䡵
Always extinguish fire with the lid. Do not
douse with water; this will fracture the
porcelain finish. Wood fires take a long
time to extinguish. The Weber FirePlace
and the ashes inside may remain hot for
some time. Leave the lid closed until the
Weber FirePlace is cold.
䡵
Do not store the Weber FirePlace with
combustible materials or ashes inside.
®
®
39935 10/93
FirePlace Assembly
Instructions
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Assembly Tools needed Screwdrivers, regular and Phillips 7/16 inch open-end or an adjustable wrench Two steel handles Two top wood handles Two bottom wood handles Two wood screws Sixteen large fiber washers Eight small fiber washers Twenty 1/4 inch steel washers Twenty-four 1/4-20 hex nuts Twenty-fo...
Step 4 Install Three Legs You will need: three legs, bottom, six machine screws,twelve large fiber washers, nine steel washers, six hex nuts,a regular screwdriver and wrench. Install only three legs as shown in Figure 3. Note that themachine screws are not installed in the same direction. CAUTION: D...
Step 7 Assemble Lower Support Ring You will need: lower support ring, upright assembly, eightmachine screws, eight hex nuts, a screwdriver and wrench. Assemble lower support ring as shown in Figure 6. Figure 6 Upper ringassembly fromStep 5 Hex nut Machine screw Lowersupport ring Step 6 Assemble Uppe...
