Weber 55052 0100 - Manual

B-1 Assembly Instructions (1) (2) Assemble wheel frame You will need: axle rod, two wheel hubcaps, twowheels, wheel frame, hammer and a block of wood.Place one end of the axle rod on the block of wood (orother protected surface). Tap one hubcap onto the endof the axle rod. Slide one wheel onto the a...

C-1 Installing Features C069.a (1) Install the right end trim piece with tool holdersand right swing-up work surfaceYou will need: Right trim piece with tool holders, rightswing-up work surface, swing-up work surface rod, one1/2 inch bolt, one nylon washer and a wrench1.) Start the right end trim pi...

C-7 Check for gas leaks m DANGER Do not use an open flame to check for gasleaks. Be sure there are no sparks or openflames in the area while you check forleaks. Sparks or open flames will result ina fire or explosion, which can causeserious bodily injury or death and damageto property. m WARNING: Yo...

D-1 Lighting Summary lighting instructions are on the control panel. 1) Open the lid.2) Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwiseto ensure that it is in the OFF position.) DANGER When the “excess gas flow control” featureis activated, a small amoun...

D-3 Lighting the Side Burner The side burner has a separate ignition system fromthe main cooking box. CAUTION: Side burner flame may be difficult to see on a bright sunny day. WARNING: If the side burner does not light: 1) Turn OFF the side burner control valve.2) Wait 5 minutes to let the gas clear...

D-5 Refilling the LiquidPropane Cylinder We recommend that you refill the LP cylinder before itis completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise).2) Unscrew regulator coupling by turning counterclockwise, by hand only. 3) Loosen cylinder lock wing nut and turn c...

D-7 Safe handling tips forLiquid Propane GasCylinders ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas atregular temperatures and pressures. Under moderatepressure, inside a cylinder, LP gas is a liquid. As thepressure is released, the liquid readily ...

D-8 Annual Maintenance After a period of nonuse, we recommend that youperform the following maintenance procedures for yoursafety. WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in anyway, do not use the barbecue. Rep...

D-9 General Maintenance Weber Spider Stopper™ Guards Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section (Venturi(1), airshutter(2), venturi fin(3) ) of the burner tubes. Thisblocks the normal gas flow, and can ...

D-10 (1) (1) (1) (2) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding the controlpanel in place. Lift off the control panel. 4) Unlatch the Spider Stopper™ Gua...

D-11 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prop...

D-12 Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Weber Spider StopperGuards for possible obstructions.(Blockage of holes.) Clean Weber Spider StopperGuards. (See Section “AnnualMaintenance”) Burners do not light. -or- Bur...

D-13 Side Burner Troubleshooting Problem Check Cure Side Burner does not light. Flame is low in HIGH position. Flame is very yellow inconjunction with the smell of gas, OR Burner makes popping noise inconjunction with the smell of gas. Push button ignition does notwork. Is gas supply off? Turn suppl...