Weber 55009 - Manual

B-1 Assembly Instructions W E B E R W EB E R (1) (2) Assemble wheel frame You will need: axle rod, two wheel hubcaps, twowheels, wheel frame, hammer and a block of wood.Place one end of the axle rod on the block of wood (orother protected surface). Tap one hubcap onto the endof the axle rod. Slide o...

C-1 Installing Features Install the right trim piece with tool holders You will need: Right trim piece with tool holdersPush the Right trim piece into the frame as shown(1),making sure that the tabs on the underside of the trimpiece are snapped into the slots in the frame.(2) (1) (2) C003.e Install ...

C-7 Check for gas leaks DANGER Do not use an open flame to check for gasleaks. Be sure there are no sparks or openflames in the area while you check forleaks. Sparks or open flames will result ina fire or explosion, which can causeserious bodily injury or death and damageto property. WARNING: You sh...

D-1 Lighting Summary lighting instructions are on the control panel. 1) Open the lid.2) Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwiseto ensure that it is in the OFF position.) DANGER: When the “excess gas flow control” feature isactivated, a small amou...

D-3 Lighting the Side Burner The side burner has a separate ignition system fromthe main cooking box. WARNING: If the side burner does not light: 1) Turn OFF the side burner control valve.2) Wait 5 minutes to let the gas clear before you try again or try to light with a match. Lighting the side burn...

D-5 Refilling the LiquidPropane Cylinder We recommend that you refill the LP cylinder before itis completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise).2) Unscrew regulator coupling by turning counterclockwise, by hand only. 3) Loosen cylinder lock wing nut and turn c...

D-6 You will need: LP cylinder, a soap and water solutionand a rag or brush to apply it.1) Turn the LP cylinder so the opening of the valve is either to the front, side or rear of the Weber GasBarbecue. Lift and hook the cylinder onto the fuelgauge. WARNING: Do not use a wrench to tighten the connec...

D-7 Safe handling tips forLiquid Propane GasCylinders ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas atregular temperatures and pressures. Under moderatepressure, inside a cylinder, LP gas is a liquid. As thepressure is released, the liquid readily ...

D-8 Annual Maintenance After a period of nonuse, we recommend that youperform the following maintenance procedures for yoursafety. WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions orcuts. If the hose is found to be damaged in anyway, do not use the barbecue. Rep...

D-9 General Maintenance Weber Spider /Insect screens Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section(1) of the burnertubes. This blocks the normal gas flow, and can causethe gas to flow back out of the air s...

D-10 (2) (1) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding thecontrol panel in place. Lift off the control panel. 4) Unhook the manifold bracket(1) and unsc...

D-11 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prop...

D-12 Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Spider/Insect Screens forpossible obstructions. (Blockage ofholes.) Clean Spider/Insect Screens. (SeeSection “Annual Maintenance”) Burners do not light. -or- Burnershave a ...

D-13 Side Burner Troubleshooting Problem Check Cure Side Burner does not light. Flame is low in HIGH position. Flame is very yellow inconjunction with the smell of gas, OR Burner makes popping noise inconjunction with the smell of gas. Push button ignition does notwork. Is gas supply off? Turn suppl...

1 Assembly Instructions Install manifold bracket You will need: manifold bracketHook the bracket(2) onto the manifold at the centerburner valve. Place your hand underneath the bracket.Lift the manifold and cooking box slightly, then hook thetab of the bracket on the frame brace(1). (1) (2) Addendum ...