Weber 41081 - Manual

B-1 Assembly Instructions B020.a (1) (2) (1) Install the slide out bottom trayYou will need: the slide out bottom tray(1), catch panholder(2), catch pan and one disposable drip pan. (1) Hook the ends of the catch pan holder into the hole inthe slide out bottom tray. The front of the catch pan holder...

C-3 Important LP Cylinder Information Failure to follow these DANGER statements exactly may result in a fire causing death or serious injury. m DANGER m NEVER store a spare LP Cylinder under or near this barbecue. m NEVER fill the tank beyond 80% full. Your Weber gas grill is equipped with a cylinde...

D-1 Lighting Summary lighting instructions are on the control panel. m DANGER Failure to open the lid while igniting thebarbecue’s burners, or not waiting 5 min-utes to allow the gas to clear if the barbe-cue does not light, may result in an explo-sive flame-up which can cause seriousbodily injury o...

D-3 Lighting the Side Burner The side burner has a separate ignition system fromthe main cooking box. m DANGER Failure to open the lid while igniting the sideburner, or not waiting 5 minutes to allow thegas to clear if the side burner does not light,may result in an explosive flame-up whichcan cause...

D-5 Using the Smoker Box The Smoker cooks with both Weber Firespice™ WoodChips and Chunks. For best results with faster cookingfoods like steaks, burgers and chops, etc., we recom-mend using the FireSpice Chips because they igniteand create smoke faster. For longer cooking foodssuch as roasts, chick...

D-6 Refilling the Liquid Pro-pane Cylinder We recommend that you refill the LP cylinder before itis completely empty. Removal of the LP cylinder 1) Close cylinder valve (turn clockwise).2) Unscrew regulator coupling by turning counter- clockwise, by hand only. 3) Loosen cylinder lock wing nut and tu...

D-8 Safe handling tips forLiquid Propane Gas Cyl-inders ■ Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas atregular temperatures and pressures. Under moderatepressure, inside a cylinder, LP gas is a liquid. As thepressure is released, the liquid readil...

D-9 Inspection and Cleaning of the WeberSpider Stopper™ Guards To inspect the Spider Stopper Guards, remove thecontrol panel and look to see if they have dust or dirton their outside surfaces. If they are dirty, brush off theoutside surface of the Spider Stopper Guards with asoft bristle brush (an o...

D-10 General Maintenance Weber Spider Stopper™ Guards Your Weber Gas Barbecue, as well as any outdoor gasappliance, is a target for spiders and other insects.They can nest in the venturi section (Venturi(1), airshutter(2), venturi fin(3) ) of the burner tubes. Thisblocks the normal gas flow, and can...

D-11 (1) (1) (1) (2) (1) Replacing Main Burners 1) Your Weber Gas Barbecue must be OFF and cool.2) Turn gas OFF at source.3) To remove control panel: take off the burner control knobs. Remove the screws holding the controlpanel in place. Lift off the control panel. 4) Unlatch the Spider Stopper™ Gua...

D-12 Crossover® Ignition System Operations If the Crossover Ignition System fails to ignite the Leftburner, light the Left burner with a match. If the Leftburner lights with a match, then check the CrossoverIgnition System. ■ Check that both the white(1) and black(2) ignition wires are attached prop...

D-13 Troubleshooting Problem Check Cure Burners burn with a yellow ororange flame, in conjunction withthe smell of gas. Inspect Weber Spider StopperGuards for possible obstructions.(Blockage of holes.) Clean Weber Spider StopperGuards. (See Section “AnnualMaintenance”) Burners do not light. -or- Bur...

D-14 Side Burner Troubleshooting Problem Check Cure Side Burner does not light. Flame is low in HIGH position. Flame is very yellow inconjunction with the smell of gas, OR Burner makes popping noise inconjunction with the smell of gas. Push button ignition does notwork. Is gas supply off? Turn suppl...

D-15 Side Burner Maintenance (2) (3) (7) (6) (5) (4) (1) (3) (2) (1) m WARNING: All gas controls and supply valves should be in the OFF position.Make sure black wire is connected between igniter andelectrode. Make sure white wire is connected betweenigniter and ground. Check that igniter lock nut is...

D-16 (1) (2) (3) (4) (5) (6) (7) (8)(9) (10) (1) (2) (3) (4)(5) (6) (7) (8) (10) (9) To Clean the Burner Head Remove the windshield and grate. Remove the burnercap. Clean with soap and water. Soak if necessary.Remove the burner ring. Clean with soap and water.Soak if necessary. m CAUTION: Do not enl...