Wayne T75S10-4 - Manual
Wayne T75S10-4 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Operating Instructions and Parts Manual; Deep Well Submersible Pump; General Safety; Table 1 - recommended fusing data; WIrInG InSTallaTIOn; do NoT handle; electrical System; WIrInG COnneCTIOnS
- Page 3 – use only control; Install circuit protection and; not; required. See Figure; Volts; none; Table 4 - Control box chart; Follow color coding when; disconnect box
- Page 4 – Installation; Too much
- Page 5 – Connect a pipe elbow, a short length; seal tape on; figure 8 - Temporary connections; STanDarD TanK HOOKUP; figure 9 - Typical Pre-charged Tank Installation
- Page 6 – figure 10 - Typical Standard Tank Installation; Troubleshooting Chart
- Page 7 – Deep Well Submersible ump
- Page 8 – limited Warranty; you
- Page 9 – Généralités Sur la; PrOPOSITIOn 65 De CalIfOrnIe; Description
- Page 10 – Instructions D’utilisation et Manual de Pièces; Puits profond pompes submersibles; Risque de choc; Système électrique; BranCHeMenTS ÉleCTrIQUeS
- Page 11 – boîte de contrôle; Suivre le codage de couleur lors du; figure 1a - Boîtier de sectionnement
- Page 12 – ÉPISSUre De fIl; Ne pas arrêter de; la fréquence
- Page 13 – InSTallaTIOn De POMPe; figure 8 - Branchements temporaires; figure 9 - Installation typique d'un réservoir chargé d'avance
- Page 14 – figure 10 - Installation typique d'un réservoir standard; Installer le dispositif d'étanchéité; Ne PAs laisser la
- Page 15 – notes
- Page 16 – Mesures Correctives; Réservoir hydropneumatiques:; Tableau de dépannage
- Page 17 – Faire marcher la pompe en dépit de la
- Page 18 – Garantie limitée; Vous; DeVeZ; garder votre reçu d’achat avec ce bulletin. Il est; nÉCeSSaIre; d’envoyer une; copie; du reçu d’achat avec le; fIXer VOTre faCTUre ICI
- Page 19 – Descripción; PrOPOSICIón 65 De CalIfOrnIa
- Page 20 – Manual de instrucciones de operación y piezas; Bomba sumergible para pozos profundos; Información general de; COneXIOneS De CaBleaDO; Sistema eléctrico; CaBleaDO/COneXIón a TIerra; No manipule la
- Page 21 – use únicamente; Instale la protección del circuito y; Voltios; nada; Tabla 4 – Cuadro de la caja de control; Siga el código de color al conectar
- Page 22 – Instalación; eMPalMe De CaBleS; Mantenga el; la frecuencia y el; Para evitar dejar
- Page 23 – InSTalaCIón De la BOMBa; NuNCA haga; figura 8 - Conexiones temporales; figura 9 - Instalación típica de un tanque precargado
- Page 24 – utilice sólo; figura 10 - Instalación típica de un tanque estándar
- Page 25 – notas
- Page 26 – Tabla de Identificación de Problemas; no intente desarmar la bomba ni
- Page 27 – Tanques de aire sobre agua:
- Page 28 – Garantía limitada; enviarnos una
Operating Instructions and Parts Manual
T50S10-2, T50S10-4, T51S10-4,
T75S10-2, T75S10-4, T100S10-2
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
For parts, product & service information
visit
www.waynepumps.com
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
340601-001 5/11
© 2011 Wayne/Scott Fetzer Company.
Deep Well
Submersible Pumps
4. Do not pump chemicals or corrosive
liquids. Pumping these liquids
shortens the life of the pumps seals
and moving parts and
WIll void
warranty.
5. When installing pump, prevent
foreign matter from falling into
well, contaminating the water and
damaging internal mechanical
components.
6. always test the water from the well
for purity before use. Check with
local health department for test
procedure.
7. Do not run the pump dry or
damage will occur and
WIll void
warranty.
All wiring should
be performed by a
licensed or certified electrician.
8. For maximum safety, the unit should
be connected to a grounded circuit
equipped with a ground fault circuit
interrupter (GFCI) device.
9. Make sure the line voltage and
frequency of electrical current
supply agrees with the motor wiring.
10. Do not attempt repairs to the
electric motor. all repairs to the
motor must be completed at a
licensed or certified electrical motor
repair shop.
11. avoid kinking electrical cord
and protect electrical cord from
sharp objects, hot surfaces,
oil and chemicals. Replace or
repair damaged or worn cords
immediately.
Risk of electric
shock! NeveR
connect the green wire (or green and
yellow wire) to a live terminal!
General Safety
Information
CalIfOrnIa PrOPOSITIOn 65
This product
contains chemicals,
including lead, known to the state of
California to cause birth defects and
other reproductive harm. Wash hands
after handling.
General SafeTy
1. Read the instruction manual
included with the product carefully.
Be thoroughly familiar with the
controls and the proper use of the
equipment.
2. Know the pump application,
limitations and potential hazards.
do NoT use to
pump flammable
or explosive fluids such as gasoline,
fuel oil, kerosene, etc. do NoT use in
explosive atmospheres. Pump should
only be used with liquids compatible
with pump component materials.
Failure to follow this warning can result
in personal injury and/or property
damage.
disconnect power
and release all
pressure from the system before
attempting to install, service, relocate
or perform any maintenance. lock the
power disconnect in the open position.
Tag the power disconnect to prevent
unexpected application of power.
3.
Personal Safety:
a. Wear safety glasses at all times
when working with pumps.
b. Keep work area clean, uncluttered
and properly lit.
c. Keep visitors at a safe distance from
work area.
Description
this submersible pump is designed to
supply water at the required pressure with
high efficiency and a long service life. to
maximize pump life, care must be taken in
its installation and usage.
Unpacking
after unpacking the submersible pump,
carefully inspect for any damage that
may have occurred during transit. Check
for loose, missing or damaged parts.
Safety Guidelines
this manual contains information
that is very important to know
and understand. this information
is provided for SaFety and to
PReVent eQUIPMent PRoBLeMS. to
help recognize this information, observe
the following symbols.
danger indicates an
imminently
hazardous situation which, if NoT
avoided, WIll result in death or serious
injury.
Warning indicates a
potentially
hazardous situation which, if NoT
avoided, Could result in death or serious
injury.
Caution indicates a
potentially
hazardous situation which, if NoT
avoided, MAY result in minor or moderate
injury.
Notice indicates
important
information, that if NoT followed, MAY
cause damage to equipment.
nOTe:
Information that requires special
attention.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Operating Instructions and Parts Manual Deep Well Submersible Pump www.waynepumps.com General Safety Information (Continued) nOTe: See Installation Wiring Diagrams for typical wiring hookups and control box identification. fuse Size HP Volts Standard Dual elem. 1/2 230 20 10 3/4 230 25 5 1 230 30 ...
3 www.waynepumps.com electrical System (Continued) use only control box specified for your pump. Make sure motor and control box match (see Table 4, on page 3). Failure to do so WIll void warranty. 4. Install circuit protection and component protection in compliance national electrical Code, Part 1....
4 www.waynepumps.com Operating Instructions and Parts Manual Deep Well Submersible Pump Installation WIre SPlICInG Splice wire to motor leads. Use only copper wire for connections to pump/motor assembly and control box. Heat shrink splice instructions (wire sizes No. 14, 12 and 10 AWG [2, 3 and 5mm ...
