Wayne Dalton 9200 - Manual
Wayne Dalton 9200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Top Bracket Installation; SET OF HOLES ON; driveTM; INSTALLATION INSTRUCTIONS INSERT; ROLLER
- Page 3 – TORQUE TUBE; SLIDE OPENER; Power Head Assembly; OPENER POWER HEAD
- Page 4 – Drum Wrap Installation
- Page 5 – Ensure that torque tube is centered and level with door.
- Page 8 – Holding handle bracket, remove all remaining slack between; Disconnect Installation; HANDLE; REMOVE; LABEL
TorqueMaster™ & idrive™
9900/9600/9200/9100
INSTALLATION INSTRUCTION
SUPPLEMENT
When installing an idrive™ opener with this door use
this supplement to the main door instructions as follows:
1) Begin with Step 1 of the main door instructions.
2) Replace Step 8 of the main door instructions with
Step 8 of the attached supplement.
3) Replace Steps 12 through 17* of the main door in-
structions with the Steps 12 through 17b of the attached
supplement.
*Supplement replaces Steps 12 - 18 on single spring doors
© Copyright 2002 Wayne-Dalton Corp.
Part No. 301528
New 07/02
1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
® Follow the corresponding steps in this insert with the steps in the installation manual provided with the door. Thesemodifications are designed to accommodate the new idrive™ garage door opener. Top Bracket Installation TOP SECTIONRIB (2) CARRIAGEBOLTS TOPBRACKET TOPBRACKETSLIDE 3) 9200/9100 Foamc...
TORQUE TUBE PLUG MOTORINTO THE OPENERPOWER HEAD SLIDE OPENER POWER HEAD LABEL(LEFT SIDE) TORQUETUBE INSERT THIS END FROM LEFT SIDE OFOPENER Continue sliding the opener power head onto the torquetube. Align the right hand bearing with the torque tube andslide the opener power head completely onto the...
Refer back to the main door manual and continue door installation at theREAR SUPPORT INSTALLATION Step 18. (Step 19 in the Single SpringTorqueMaster™ Installation Instructions) After door installation is completed, refer to the idrive™ owner’s manual,starting at the PRE-OPERATION INSTALLATION sectio...
