Wayne Dalton 346918 - Manual
Wayne Dalton 346918 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Parts Breakdown
- Page 3 – Important Safety Instructions; WARNINg; Tools Required
- Page 4 – Door Section Identification; Removing an Existing Door; A POWERFuL SPRINg RELEASINg ITS ENERgy SuDDENLy CAN CAuSE SEvERE; Preparing the Opening
- Page 6 – InstallatIon; quick Install Flag Angles; Fully Adjustable Jamb Brackets
- Page 7 – Cable Drum Assemblies and Track Rollers
- Page 8 – FAILuRE TO ENSuRE TIgHT FIT OF CABLE LOOP OvER MILFORD PIN COuLD; Bottom Section
- Page 9 – Top Fixtures; Drawbar Operator Bracket
- Page 10 – Top Section; Adjusting Top Fixtures; End Bearing Brackets
- Page 11 – Center Bracket Bushing Assembly; Torsion Spring Assembly
- Page 12 – Counterbalance Lift Cables; FAILuRE TO PLACE vICE CLAMPS ONTO vERTICAL TRACk CAN ALLOW; Winding Springs
- Page 13 – Rear Back Hangs
- Page 15 – Door Arm Hookup; Inside Lock; Pull Down Rope; DO NOT INSTALL PuLL DOWN ROPE ON DOORS WITH OPERATORS. CHILDREN; optional Installation
- Page 16 – TACHED TO THE SPRINgS ARE uNDER ExTREME TENSION, AND IF HANDLED; Maintenance
- Page 17 – SCREWS ON THE COuNTERBALANCE (END OR CENTER BEARINg BRACkETS)
- Page 18 – Lifetime Limited Warranty; for as long as you own the door; warranty
- Page 20 – Please Do Not Return This Product To The Store; thank you for your purchase.; Find a Dealer; section online at
GARAGE DOORS & OPENERS
Part No.
IMPORTANT NOTICES!
Wayne-Dalton highly recommends that you read and fully under-
stand the Installation Instructions and Owner’s Manual before you
attempt this installation.
To avoid possible injury, read the enclosed instructions carefully
before installing and operating the garage door. Pay close attention
to all warnings and notes. After installation is complete, fasten this
manual near garage door for easy reference.
The complete Installation Instructions and Owner’s Manual are
available at no charge from:
Wayne-Dalton, a Division Of Overhead Door Corporation,
P.O. Box 67, Mt. Hope, OH., 44660,
Or Online At
www.Wayne-Dalton.com
S
tandard
L
ift
MH
inStaLLation
inStructionS
and
owner
’
S
ManuaL
t
o r S i o n
6100
T a b l e O f C o n t e n t s
346918
REV6_03/01/2012
©Copyright 2012 Wayne-Dalton, a Division Of Overhead Door Corporation
Parts Breakdown
2
Pre-Installation
3
Important Safety Instructions
3
Tools Required
3
Package Contents
3
Door Section Identification
4
Removing an Existing Door
4
Preparing the Opening
4
Installation
6
Optional Installation
15
Door Arm Hookup
15
Inside Lock
15
Pull Down Rope
15
Maintenance
16
Cleaning Your Garage Door
16
Painting Your Garage Door
16
Operation and Maintenance
16
Warranty
18
Dealer Locator Information
20
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com A. FLAg ANgLES (AS REquIRED): A1. Fully Adjustable (F...
Important Safety Instructions DEFINITION OF kEy WORDS uSED IN THIS MANuAL: WARNINg WARNINg INDICATES A POTENTIALLy HAzARDOuS SITuATION WHICH; IF NOT AvOIDED, COuLD RESuLT IN SEvERE OR FATAL INJuRy. CAuTION: PROPERTY DAMAGE OR INJURY CAN RESULT FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORTANT: REQUIRED...
5/16” x 1 5/8” Hex head lag screws (as required) (4) 1/4”-20 x 5/8” Carriage bolts 1/4”-20 x 9/16” Track bolts (as required) 1/4”-14 x 5/8” Self tapping screws (as required) (2) 3/8”-16 x 3/4” Truss head bolts Cotter pin 5/16” x 1-1/4” Clevis pin Drawbar operator bracket arm 3/8”-16 x 1-1/2” Hex bol...
