Wagner 9145 - Manual

English 5 Proper use and functions Start Controls and Functions ON/OFF switch: The ON/OFF switch turns power to sprayer on and off. (O=OFF, |=ON) PRIME/SPRAY knob: The PRIME/SPRAY knob directs material to the material return tube when set to PRIME or to spray hose when set to SPRAY. Pressure Control...

English 7 Safety Start Pressure Relief Procedure* *Perform when instructed Start Important Safety Warning Be sure to follow the Pressure Relief Procedure when shutting the unit off for any purpose. This procedure is used to relieve pressure from the spray hose. Failure to do so could result in serio...

English 8 2. Load Material Start You will need: • The material you plan to spray • Flat blade screwdriver (cart models only) • Light household oil / Piston Oil™ • Extension cord • Waste bucket 1. Remove AutoOiler cap with a flat blade screwdriver. Squirt Separating Oil into the AutoOiler. Replace ca...

You will need: • Waste bucket • Scrap material / cardboard • Drop cloths to protect floors and furnishings from overspray note: Motor will cycle ON and OFF while spraying to regulate pressure. This is normal. English 9 3. Getting Material to Flow Start note: Motor will cycle ON and OFF while sprayin...

English 10 4. Practice Spraying Start You will need: • Scrap material / cardboard Notes: If the spray pattern becomes distorted or stops completely while the gun is triggered, follow any or all the procedures listed on pages 12-14.If you plan to be away from your spray project for more than one hour...

English 11 Spray Pattern Overlap Your Strokes Spray technique 50% Overlap 8” - 10” (20 - 25 cm) ! GOOD SPRAY PATTERN BAD SPRAY PATTERN: TAILING CORRECT See page 12-14 Start stroke End stroke Pull trigger Release trigger Move steadily CORRECT CORRECT INCORRECT tip: Flex your wrist as you move in orde...

English 12 Spraying Troubleshooting - Clear the Spray Tip Start You will need: • Scrap material / cardboard Do not attempt to unclog or clean the tip with your finger. High pressure fluid can cause injection injury. 1. Lock the spray gun. 2. Rotate spray tip 180 degrees from its current position. no...

English 13 Spraying Troubleshooting - Clean the Spray Gun Filter Start You will need: • Wrench • Warm, soapy water for latex material • Mineral spirits for oil based materials • Replacement spray gun filter (if necessary) ImPORTanT: never clean the filter by poking it with a sharp object. 1. Peform ...

English 14 Spraying Troubleshooting - Clean the Inlet Filter Start You will need: • Warm, soapy water for latex material • Mineral spirits for oil based materials ImPORTanT: make sure your floors and furnishings are covered with drop cloths to prevent accidental drips. 1. Unscrew the inlet filter fr...

English 15 Short Term Storage Start English You will need: • Water • Plastic bag or bucket • Rags • Stir stick This procedure should be used when taking a short term break or when ending your project for the day. If your break is longer than 16 hours follow Cleanup instructions, page 16. Instruction...

English 16 Cleanup Start You will need: • A water source that can be delivered with a garden hose (latex materials only) • Mineral spirits if using oil-based material • Empty waste container • A container with warm, soapy water • When using latex material, clean sprayer and components with warm, soa...

English 18 Cleanup - Oil-Based Materials Start You will need: • Mineral spirits if using oil-based material • Warm, soapy water if using latex material • Waste container Follow these steps if you sprayed oil-based materials, or if you sprayed latex materials and do not have a garden hose available. ...

English 19 Cleaning the Spray Gun Components Start You will need: • Soft bristled brush • Light household oil • Warm, soapy water if using latex material • Mineral spirits for oil based material • Wrench 1. Peform the Pressure Relief Procedure , page 7. 5. Install gun filter tapered- end first. Reas...

English 20 Long Term Storage Start You will need: • Light household oil / Piston Oil™ • Rags • Wrench ImPORTanT: Store the unit indoors with the power cord wrapped around the cord wrap or stand. 1. Remove the suction tube. Using a wrench, remove the spray hose. 2. Fill a cup or other container with ...

English 22 Troubleshooting Before servicing, always release system pressure by following Pressure Relief Procedure (page 7). Problem A: The sprayer does not start Cause Solution 1. Sprayer is not plugged in Plug sprayer in 2. ON/OFF switch is set to OFF Turn ON/OFF switch to ON 3. The sprayer shuts ...

English Français Español 72 1 2 3 5 4 Sprayer • Pulvérisateur • Rociador Parts List • Liste de Pièces • Lista de Piezas This unit contains no electrical servicable parts. Do not attempt to service yourself. Store indoors with the cord wrapped around the cord wrap or stand. Cette unité n’a aucune piè...

English Español Français Español 73 4 1 2 3a 5 6 7 3b Suction set • Dispositif d’aspiration • Juego de succión Parts List • Liste de Pièces • Lista de Piezas Item art. art. Part no. no de piéce Pieza no. English - Description Français - description Español - Descripción qty. qté. Cant. 1 0516197 Suc...

English Español Français Español 75 Accessories • Accessoires • Accesorios Part no. no de piéce Pieza no. English - Description Français - description Español - Descripción 0512221A Piston repair kit (9145/9155) Jeu de joints pour tronçon d’acheminement (9145/9155) Juego de reparación del pistón (91...