Vulcan LG500 Manual - Free PDF Download

Page 2 - IMPORTANT FOR YOUR SAFETY

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATI...

Page 3 - TABLE OF CONTENTS

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY………………………………………. 2 INTRODUCTION…………………………………………………………… 4 GENERAL…………………………………………………………… 4 ORDERING PARTS………………………………………………… 4 FRYER CAPACITIES………………………………………………. 4 UNPACKING…………………………………………………...

Page 4 - INTRODUCTION; Crumb Rack; MODEL

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -4- INTRODUCTION GENERAL Vulcan Fryers are produced with quality workmanship and material. Proper installation, usage and maintenance will result in years of satisfactory performance. Before installing the fryer, thoroughly read this manua...

Page 5 - INSTALLATION

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -5- INSTALLATION Before installing the fryer, verify that the type of gas (natural or propane) agrees with the specifications on the fryer data plate, which is located on the inside of the door panel. Make sure the fryer is configured for ...

Page 6 - CODES AND STANDARDS; In the United States:; State and local codes, or in the absence of local codes, with:; ASSEMBLY; Comply with

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -6- CODES AND STANDARDS The fryer must be installed in accordance with: In the United States: State and local codes, or in the absence of local codes, with: National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). Copies may be o...

Page 7 - GAS CONNECTION

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -7- Locate the fryer under a hood with adequate connection to an exhaust duct. The hood must extend 6” (15 cm) beyond fryer on both sides. Clearance above the fryer should be adequate for combustion byproducts to be removed efficiently...

Page 8 - Prior to lighting, check all joints in the gas supply line for leaks.

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -8- Make sure the pipes are clean and free of obstructions, dirt, and piping compound. A battery requires one or two connections of appropriate size for the gas requirement. Prior to lighting, check all joints in the gas supply line for le...

Page 9 - complying with the above codes.; LEVELING THE FRYER

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -9- When installing a quick disconnect you must also install a means for limiting the movement of the fryer. This device will prevent the gas line or quick disconnect from being strained. The restraining device should be attached to the ...

Page 10 - OPERATION; Hot oil and parts can cause burns. Use care when operating,; OVER-TEMPERATURE SHUTDOWN; Cleaning; Do not use chlorine or sulfate/sulfide cleaners.

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -10- OPERATION Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank. OVER-TE...

Page 11 - FILLING TANK WITH SHORTENING; shortening will damage the tank and void your warranty.

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -11- FILLING TANK WITH SHORTENING Solid shortening should NOT be used with LG300 fryers. Melting solid shortening will damage the tank and void your warranty. Close the drain valve. Fill the fryer tank with liquid shortening. Shorten...

Page 12 - LIGHTING THE PILOT; If gas supply is interrupted, repeat steps 2 through 6.

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -12- LIGHTING THE PILOT 1. Open the door. 2. Turn the thermostat OFF (see figure below, view A). The thermostat is located behind the door. 3. Push the gas control valve knob and turn to OFF. Wait 5 minutes for unburned gas to vent. 4. Pus...

Page 13 - TURNING ON THE FRYER

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -13- TURNING ON THE FRYER Set the temperature knob to desired temperature. After the set temperature has been reached, the thermostat shuts off the gas flow to burners. The pilot remains lit. The burners will cycle on and off, mainta...

Page 14 - Fry Basket Capacity:; EXTENDING SHORTENING LIFE

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -14- Fry Basket Guidelines Do not overfill baskets. (See table for recommended basket capacities below) Carefully lower basket into oil. When frying doughnuts and fritters, turn product only once during frying. When cooking French fr...

Page 15 - DRAINING THE TANK; Turn the thermostat to OFF.; DAILY FILTERING; Hot oil and hot parts can cause burns. Use care when operating,

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -15- DRAINING THE TANK 1. Turn the thermostat to OFF. 2. To keep the pilot lit, turn the gas valve to PILOT. 3. Direct the drain spout into the container that you want to drain the shortening into. 4. Open the drain valve. The oil will dra...

Page 16 - CLEANING; Clean all exterior surfaces of your fryer at least once daily.

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -16- CLEANING Hot oil and hot parts can cause burns. Use care when operating, cleaning, and servicing the fryer. Daily Clean your fryer regularly with the tank brush along with a damp cloth, and polish with a soft dry cloth. If regular cle...

Page 17 - BOIL OUT PROCEDURE

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -17- Remove discolorations by washing with any detergent or soap and water. Use a self-soaping, non-metallic scouring pad for particularly stubborn discolorations. Always rub with the grain of the stainless steel. Do not use a meta...

Page 18 - MAINTENANCE; FLUE VENT INSPECTION; Probable

LG SERIES GAS FRYERS VULCAN-HART F-32910 Rev. H (April 2008) -18- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleaning, and servicing the fryer. Spilling hot fryer compound can cause severe burns. Do not move fryer without draining all frying compound from the tank. F...