VTech CS6114-2 - Manual

Table of Contents:

• Page 2 – Congratulations; read; Important safety instructions on page 31; efficiency guidelines.; Telephones identified with this logo have reduced noise and
• Page 3 – ii; Table of contents; Technical specifications
• Page 4 – Parts checklist; original packaging in the event warranty service is necessary.; Getting started
• Page 5 – Telephone base and charger installation; through your telephone line, you must install a; Wall mounting; top hole at the back of the telephone
• Page 6 – Battery installation; after a power failure. For instructions, see; Set date and time on page 9. To; Install the battery as shown below.; THIS SIDE UP facing up and the wires; inside the battery compartment.; CHARGE light remains on whenever the handset is charging.; remove the battery to prevent any possible leakage.; CHARGE
• Page 7 – Battery charging; for at least 30 minutes to give the handset enough charge to use the; Low battery; along with a flashing; Place in; flashes; Low battery and; in the battery, the screen displays; Telephone base layout
• Page 8 – Handset layout
• Page 10 – Ringer volume; setting flashing. Press; Ringer tone; hear a confirmation tone.; If the ringer volume is set to; Off, the idle screen displays Ringer off.; When the ringer volume is set to; Off, the handset still rings when you; press; Telephone settings; Using the menu
• Page 11 – LCD language; appear; Your telephone service provider may alert you of new
• Page 12 – Key tone; to confirm your selection. You hear a; Set date and time; When the month is flashing, press; time needs to be reset.
• Page 13 – Home area code; to confirm. You hear a confirmation tone.; Dial mode; to confirm your selection. You hear a confirmation tone.; Website; area code when making a local call, or, if you move to a location that
• Page 14 – The screen shows the elapsed time as you talk (in hours, minutes; or; /CANCEL to backspace and delete press and hold; to insert a dialing pause (a; Telephone operation
• Page 15 – Temporary ringer silencing; and then; Temporary tone dialing; Use this feature to find; /FIND HANDSET on the telephone; All system handsets ring and flash; /FIND HANDSET on the telephone base once and then release.; Do not press and hold; /FIND HANDSET for more than four seconds.; It may lead to handset deregistration. If; Not registered displays on the
• Page 16 – Chain dialing; Each handset stores the five most recently dialed numbers.; Review the redial list; about the redial memory.; /CANCEL to exit redial, directory or call log when you are on
• Page 17 – Dial a redial entry; /DELETE to delete the displayed number. You hear a; Directory; handset are not reflected on the other handset.
• Page 18 – Add a directory entry; to confirm. The screen displays
• Page 19 – Character chart; Number; Review the directory; CID or; /SELECT and then press CID or
• Page 20 – Alphabetical search
• Page 21 – Delete a directory entry; Search for the desired entry in the directory (see; Review the directory on page 16 or Alphabetical; to confirm. The screen; About caller ID; time of calls. Some names and numbers may not show because they are
• Page 22 – Call log; more than 15 characters, only the first 15 characters are shown and; Not available displays.; Missed call indicator
• Page 23 – Memory match; View dialing options; # repeatedly to display all
• Page 24 – Dial a call log number; If there is no caller ID information, the screen displays; Unable to save and you
• Page 25 – Delete the call log entries; and then you hear a confirmation tone.; Call log display screen messages
• Page 26 – MUTE is turned off and the person on the other end can; Display screen messages; Appendix
• Page 27 – Handset and telephone base indicators; Handset light; On when the handset is charging in the telephone base or charger.; Telephone base light; Battery status - flashes when the battery is low and needs charging.; NEW
• Page 28 – Battery; charged, you can expect the following performance:; Operation; The battery needs charging when:; conductive materials.
• Page 29 – Troubleshooting; telephone base to synchronize.; There is no dial tone.; /FIND HANDSET on the telephone base for about four; confirmation tone when the
• Page 30 – Low battery shows on the handset screen.; Place the handset in the telephone base or charger for recharging.; The battery does not charge in the handset or the handset battery; CHARGE light on the handset should be on.; handset is not on, refer to; The CHARGE light is off below.; handset before; The CHARGE light is off.; to one minute for the handset and telephone base to reset.; The telephone does not ring when there is an incoming call.; minute for this to take place.
• Page 31 – My handset beeps and is not performing normally.; possible from these types of electronic devices.; out when I am using the cordless handset.; information about DSL filters.; I hear other calls when using the telephone.; telephone service. Contact your telephone service provider.; I hear noise on the cordless handset and the keys do not work.; Make sure the telephone line cord is plugged in securely.
• Page 32 – The caller ID information displays after the first or second ring.
• Page 33 – I cannot retrieve voicemail messages.; information on how to access your voicemail.; I subscribe to a nontraditional telephone service that uses my; service. Contact your service provider for more information.; Common cure for electronic equipment.; to one minute for this to take place.
• Page 34 – Important safety instructions; SAVE THESE INSTRUCTIONS
• Page 35 – Precautions for users of implanted cardiac pacemakers; Maintenance
• Page 36 – About cordless telephones
• Page 37 – Warranty
• Page 38 – Please retain your original sales receipt as proof of purchase.; FCC, ACTA and IC regulations
• Page 41 – Index; DSL filter