Page 3 - Contents
Contents Government regulations .....................................................................................5 Warning! Safety first .........................................................................................7 What’s included .......................................................
Page 5 - Government regulations
5 © 2008 Directed Electronics. All rights reserved. Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol-lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including i...
Page 7 - Warning! Safety first
7 © 2008 Directed Electronics. All rights reserved. Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can ...
Page 9 - What’s included; Your warranty
9 © 2008 Directed Electronics. All rights reserved. What’s included Two five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control center with integrated status LED and Valet override switch • A remote start defeat toggle switch • Window decals • Your warranty regist...
Page 10 - System maintenance; Low battery indicator; Using a small slot-
10 © 2008 Directed Electronics. All rights reserved. ➤ System maintenance The system requires no specific maintenance. Your remotes are powered by small coin cell lightweight 3-volt lithium batteries that last approximately one year under normal use. The remote uses one CR2032 cell battery. When the...
Page 11 - Turn both the unit; Two car operation
11 © 2008 Directed Electronics. All rights reserved. Turn both the unit 2. front and circuit board over, remove battery from clip and replace. Note: Verify that the bat- tery polarity is correct when replacing. Reposition all parts and snap together. 3. ➤ Two car operation You can use the remote con...
Page 12 - Note: If Keypad Lock is On, press and then press
12 © 2008 Directed Electronics. All rights reserved. 1-way remote 1 3456 2 A U X Feature Description 1 Transmit indicator 2 Lock button Press for one second to lock. 3 Unlock button Press for one second to unlock. 4 Remote start button Press for one second to activate remote start. 5 Auxiliary butto...
Page 13 - Transmitter configuration
13 © 2008 Directed Electronics. All rights reserved. ➤ Transmitter configuration Button Level Direct Access A U X x 1 A U X x 2 A U X x 3 A U X x 4 A U X Lock Silent Lock A U X Unlock Silent Unlock Valet Mode Car Finder A U X Remote Start Reset Runtime Timer Mode Smart Start Rear Defogger A U X Trun...
Page 14 - Feature list
14 © 2008 Directed Electronics. All rights reserved. ➤ Feature list A U X Unlock Command : Press one time to Lock Notes : Press/hold for 1.5 seconds to lock the system and then activate the Panic output* A U X Unlock Command : Press one time to Unlock A U X Remote Start Command : Press one time to a...
Page 16 - Smart start; Aux 3; Rear defogger; Panic
16 © 2008 Directed Electronics. All rights reserved. Smart start Command : Press A U X three-times and then press A U X . Notes : Enables or disables the Smart Start feature. The parking lights flash fast 5 times when turning the feature on, and flash slowly 5 times when turning the feature off. Aux...
Page 17 - Using the system; Locking the vehicle; Unlocking the vehicle
17 © 2008 Directed Electronics. All rights reserved. Using the system ➤ Locking the vehicle To lock the vehicle, press the button on the remote control. The horn in the vehicle “honks” one-time, and the parking lights flash one-time. If the power door locks have been connected, the doors lock. The s...
Page 18 - Valet mode; Panic Mode
18 © 2008 Directed Electronics. All rights reserved. ➤ Valet mode You can prevent your system from automatically activating the Failsafe® Starter Kill. When the system is in Valet mode, the feature is disabled. The doors do not automatically lock. This is useful when washing or having the vehicle se...
Page 19 - Remote feature programming
19 © 2008 Directed Electronics. All rights reserved. ➤ Remote feature programming The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See page 12) To program the remote user features: Press and hold the 1. A U X button on the remote for 12...
Page 20 - Overriding the optional starter kill
20 © 2008 Directed Electronics. All rights reserved. ➤ Overriding the optional starter kill To bypass the optional starter kill without a remote control: Use your override switch located on the control center (see diagram below) to bypass the system. This switch bypasses the system only if you have ...
Page 21 - Using the remote start
21 © 2008 Directed Electronics. All rights reserved. Using the remote start Read this user guide, including the Warnings section at the beginning of this guide before using the remote start . Ensure that the vehicle is parked in an open area, not in a garage. To use your remote start to pre-warm or ...
Page 22 - Manual transmission vehicles
22 © 2008 Directed Electronics. All rights reserved. ➤ Manual transmission vehicles If the vehicle has manual transmission the proper steps must be followed before leaving the parked vehicle, or the remote start feature is disabled. This process is called MTS, manual transmission start. While the ve...
Page 23 - Timer mode
23 © 2008 Directed Electronics. All rights reserved. ➤ Timer mode This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine. Note: T...
Page 24 - Turbo timer mode
24 © 2008 Directed Electronics. All rights reserved. To exit timer mode without the transmitter: Make sure the remote start system is not operating the engine. 1. Turn the ignition on. Timer Mode is exited and the parking lights flash 2. slowly four times. Note: The Bitwriter can change the amount o...
Page 25 - Smart start activation
25 © 2008 Directed Electronics. All rights reserved. To enter turbo timer mode with a manual transmission: Perform the manual transmission procedure (See p. 22) with the door open. Transmit the timer mode feature with the remote by pressing two-times, and then press A U X . After exiting the vehicle...
Page 27 - Turning on the rear defogger
27 © 2008 Directed Electronics. All rights reserved. ➤ Turning on the rear defogger The rear defogger (if connected) is programmed to automatically activate when remote start is turned on. If the interior cabin temperature is above 55˚ F the defogger will not activate. To manually activate the rear ...
Page 28 - Safety features; Optional starter anti-grind circuitry; Disabling the remote start system
28 © 2008 Directed Electronics. All rights reserved. Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. ➤ Optional starter anti-grind circuitry Whenever the vehicle is remote started...
Page 29 - Diagnostics; Locking; The optional horn honk feature must be; Remote start
29 © 2008 Directed Electronics. All rights reserved. Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit. ➤ Locking If the system is locked at the same time that the door input is active, you will hear one horn honk to i...
Page 30 - Owner recognition
30 © 2008 Directed Electronics. All rights reserved. Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user. This feature is only available to authori...
Page 31 - Programming options
31 © 2008 Directed Electronics. All rights reserved. Programming options Your system has many custom programmable options. Some may require instal- lation labor. Ask your authorized dealer for details. The following is a list of the programmable options, with the factory settings in Bold . Active • ...
Page 32 - Convenience expansions
32 © 2008 Directed Electronics. All rights reserved. Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Power Trunk Release: The accessory output of the system can operate a fac- ...
Page 33 - Glossary of terms
33 © 2008 Directed Electronics. All rights reserved. Glossary of terms Control Center: The control center contains the system’s radio-frequency antenna, the valet and override switch, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windsh...
Page 35 - Quick reference guide
35 © 2008 Directed Electronics. All rights reserved. Quick reference guide Locking • To lock press for one second. The doors lock. The LED on the control center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking. Unlocking • To unlock press 1 3456 2...
Page 37 - Limited lifetime consumer warranty
37 © 2008 Directed Electronics. All rights reserved. Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding withou...
Page 40 - The company behind this system is Directed Electronics
G4102V 2008-09 Vista, CA 92081 www.directed.com © 2008 Directed Electronics—All rights reserved The company behind this system is Directed Electronics Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and acce...
