Viking VRBD/VUBD 24" W - Manual
Viking VRBD/VUBD 24" W – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – BUILT-IN INSTALLATION; Select Location; ELECTRICAL CONNECTION; Proper Disposal of Your Old Refrigeration Product
- Page 3 – LEVEL UNIT
- Page 4 – DIMENSIONS - FREESTANDING MODELS; FRONT
- Page 5 – Rear Wall
- Page 6 – DIMENSIONS - UNDERCOUNTER MODELS
- Page 7 – ASSEMBLY; It is
- Page 9 – TAPPING PROCEDURES; TWIN PROBE KEG TAPS; Insert Probes; and Budweiser; Quarter Barrel
- Page 10 – not use strong cleaners or scouring powder or pads.
- Page 11 – OPERATING INSTRUCTIONS; WIRING DIAGRAM
- Page 12 – HOW TO DRAW THE PERFECT GLASS OF BEER; Start with a clean beer glass that has been
- Page 13 – DESCRIPTION; Wild Beer
- Page 14 – Condenser
- Page 15 – ONE YEAR FULL WARRANTY
USE/INSTALLATION
INSTRUCTIONS
VRBD/VUBD 24” W. BEVERAGE DISPENSER
Retain for Future Reference
VIKING RANGE CORPORATION
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely and carefully.
•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
•The installer should leave these instructions with the consumer for future reference.
GENERAL INFORMATION
1. A
ALLW
WA
AY
YS
S connect CO2 gas cylinder to reducing valve or regulator
2. N
NE
EV
VE
ER
R connect gas cylinder directly to keg.
3. A
ALLW
WA
AY
YS
S secure gas cylinder in upright position.
4. A
ALLW
WA
AY
YS
S keep gas cylinder away from heat.
5. N
NE
EV
VE
ER
R drop or throw gas cylinder.
6. A
ALLW
WA
AY
YS
S ventilate after CO2 leakage.
7. Gas cylinders should be stored in the coolest part of the room, preferably at 70
o
F., and securely fastened in the
upright position before the primary regulator is attached to the cylinder
B
BE
EE
ER
R D
DIIS
SP
PE
EN
NS
SIIN
NG
G K
KIIT
T C
CO
ON
NS
SIIS
ST
TS
S O
OF
F::
•Draft Tower Assembly
•Drain Hose
•Drain Container
•Keg Coupler
•Air Line with Clamps
•Single Gauge Regulator
•Filled 5 lb. CO2 Cylinder
T
TO
OO
OLLS
S N
NE
EE
ED
DE
ED
D::
•Crescent Wrench
•Pliers
•Screwdriver
Draft Tower
Assy
Regulator
Regulator
Coupling Nut
Pressure
Gauge
Keg Coupler
(Sankey type
shown)
Drum Valve
Set Screw
Air
Line
Beer Line
CO2 Tank
Toggle Shut
Off Valve
CO
2
CAN BE DANGEROUS
If it becomes difficult to breathe and
your head starts to ache, abnormal
concentrations of carbon dioxide may
be present in the area. Leave the
room immediately.
41006170 Rev. F
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 BUILT-IN INSTALLATION Select Location The proper location will ensure peak performance of your appliance. Choose a location where the unit will be out ofdirect sunlight and away from heat sources. Units with fan cooled condensers can be built-in. Unit should be operated in a properly ventilated ar...
3 CASTERS Your beverage dispenser is equipped with four casters. thefront two casters can be locked. For built-in applications, the four casters can be removed byremoving the nut located inside the dispenser cabinet andthen pulling the threaded caster spindle through the base ofthe unit. CABINET CUT...
4 DIMENSIONS - FREESTANDING MODELS FRONT SIDE TOP 24 5/8”(62.5 cm) 41 25/32”(106.2 cm) 4 3/16”(10.6 cm) 2 1/16”(5.2 cm) 1 1/4”(3.2 cm) 35 9/16”(95.4 cm) 25 1/8” (63.8 cm) 12 7/8” (32.7 cm) 24 5/8”(62.5 cm) 22” (55.9 cm) 13 3/4”(34.9 cm) 12 5/16” (31.3 cm) 23 1/8” (58.7 cm) 3/4” (1.9 cm) TYP 3/4” (1....
