Viking F20495 - Manual - manualsarea.com

Page 2 - DANGER

IMPORTANT– Read and Follow! 3 2 Table of Contents Warnings & Important Safety Instructions _____________________________________________________ 3 Dimensions __________________________________________________________________________________ 6 Specifications ______________________________________...

Page 3 - IMPORTANT–; Electrical shock hazard.; WARNING

IMPORTANT– Read and Follow! 5 4 DANGER Gas leak hazard. To avoid risk of personal injury or death; leak testing of the appliance must be conducted according to the manufacturer’s instructions. Before placing appliance in operation, always check for gas leaks with soapy water solution. • DO NOT USE A...

Page 4 - Dual Fuel 30” Range

Specifications 7 Dimensions 6 Dual Fuel 30” Range Dual Fuel 30” Range Description VDSC530-4B Overall width 29-7/8” (75.9 cm) Overall height To top of side trim 35-7/8” (91.1 cm) min. 37” (94 cm) max. Legs adjust 1-1/8” (2.9 cm) Overall depth fromrear To end of side panel—25-3/4” (65.4 cm)To end of l...

Page 5 - Clearance Dimensions; CAUTION

42 ” m in. (10 6.7 cm ) 13 ” m ax . ( 33 .0 cm ) 6” min . (15.2 cm ) 18 ” m in. (45 .7 cm ) 3/ 8” (0. 95 cm ) 36 ” ( 91 .4 cm ) 29-7 /8” (75.9 cm ) Clearance Dimensions (Wood/Composite Overlay) 9 Clearance Dimensions (Proximity to Cabinets) 8 • This range may be installed directly adjacent to existi...

Page 6 - Electrical & Gas Requirements

11 Electrical & Gas Requirements Flexible Connections: If the unit is to be installed with flexiblecouplings and/or quick-disconnect fittings,the installer must use a heavy-duty AGAdesign-certified flexible connector of at least1/2” (1.3 cm) ID NPT (with suitable strainreliefs) in compliance wit...

Page 7 - NOTICE; Door Removal

13 12 General Information Installation READ AND FOLLOW ALL WARNINGAND CAUTION INFORMATION WHENINSTALLING THIS APPLIANCE. • All openings in the wall behind the appliance and in the floor under theappliance must be sealed. • Do not obstruct the flow of combustion and ventilation air. Moving, Handling,...

Page 8 - Leg Installation

14 15 1 Remove access door. Electrical Connection (3-wire) Note: If you have a 4-wire connection, see following section for 4-wire connection instructions. Use a 3-wire power supply cord kit rated for40 amps – 125/250 volts with closed loopterminals and marked for use with ranges. Do not use a GFI c...

Page 11 - Connecting Gas & Electric; Anti-tip Device Installation

21 20 1 Me asu rem ent (A) Measur ement (A) Me asu rem ent (A) 2 Me as ure me nt (A ) Measur ement (A) +1 /2 ” +1/2” (1. 3 c m) (1.3 cm) Me as ure me nt (A ) +1 /2 ” (1. 3 c m) 3-5 /8” 3-5/8” (9.2 cm ) (9.2 cm) 3-5 /8” (9.2 cm ) Measure from floor to bottom of the anit-tip opening located on the bac...

Page 12 - Door Replacement and Adjustment; Final Installation

22 23 1 2 Reattach door to range. Open door completely. Reattach hinge trim. 3 4 Remove pins from hole in hinges. Close door. 5 If the door needs to be adjusted, loosen hinge trim screws located in step 2. Adjust the screws located between the door and kickplate using a 5/32” hex head allen wrench. ...

Page 13 - These installation instructions should remain with the unit; Service & Registration

25 24 Only authorized replacement parts may be used in performing service on the appliance.All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (854-4641), for the nearest service partsdistributor in your area or write to: VIKING RANGE CORPORATI...

Viking F20495 - Manual

Table of Contents:

Summary

Other Viking Models