Viking Combination Beverage Center - Manual

Page 2 - •FOR YOUR SAFETY•; •SAVE THESE INSTRUCTIONS•; DANGER; PROPER DISPOSAL OF YOUR OLD REFRIGERATION PRODUCT

Retain for Future ReferenceIMPORTANT - PLEASE READ AND FOLLOW •• Before beginning, please read these instructions completely and carefully. • Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. • Please observe all local and national codes and ...

Page 3 - UNDERCOUNTER CABINET CUTOUT

3 A B C UNDERCOUNTER CABINET CUTOUT *24” width for cabinet only. 24 1/4” (61.6 cm) need for cabinet and door width clearance ifdoor is recessed between cabinets. SPECIFICATIONS/DIMENSIONSPROFESSIONAL SERIES B Baassiicc E Elle eccttrriicc D Daattaa •115 VAC/60 Hz•Maximum amps - 3.3•Approximate Shippi...

Page 6 - FULL OVERLAY PANEL INSTALLATION

6 FULL OVERLAY PANEL INSTALLATION Note: Weight of wood panel must not exceed 20 lbs. W Wo oo od d S Sccrre ew wss 1. A #8 pan head wood screw should be used to properly secure the wood frame. A total of 10 screws will be needed for a 3 1/2” (8.9 cm) kickplate or 8 screws for a 4” (10.2 cm) kickplate...

Page 7 - SELECTING AND PREPARING THE OVERLAY PANEL

7 SELECTING AND PREPARING THE OVERLAY PANEL F FO OR R A A 3 3--1 1//2 2”” T TO OE E K KIIC CK K ((C CO OV VE ER RS S T TH HE E E EN NT TIIR RE E D DO OO OR R E EX XT TR RU US SIIO ON N)) M Miin n.. 5 5//8 8”” ((1 1..7 7 ccm m)) M Maaxx.. 3 3//4 4”” ((1 1..9 9 ccm m)) 2 23 3 3 3//4 4”” ((6 60 0..3 3 ...

Page 9 - ATTACHING THE OVERLAY PANEL TO THE DOOR

9 ATTACHING THE OVERLAY PANEL TO THE DOOR 1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove the door by angling the door off of the bottom hinge pin. 2. Peel back the door gasket to expose the screw holes. 3. Set the overlay panel flus...

Page 10 - WARNING; FINAL PREPARATION

10 ELECTRICAL CONNECTION E Elle eccttrriiccaall R Re eq qu uiirre em me en nttss A 115 volt, 60 Hz, AC only 15 amp fused electrical supply is required. (Atime delay fuse or circuit breaker is recommended.) It is recommendedthat a separate circuit, serving only this appliance, be provided. ••E ELLE E...

Page 13 - INTERIOR LIGHT; CAUTION

13 INTERIOR LIGHT WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect the power cord when changingthe light bulb may result in electrical shock. CAUTION The ice maker must have all water drained and removed to prevent damages aswell as possible water damage to the surrounding area in freezing cond...

Page 15 - TROUBLESHOOTING CHART

15 TROUBLESHOOTING CHART P Prro ob blle em m P Po ossssiib blle e C Caau usse e S So ollu uttiio on n Odor in cabinet Interior needs cleaning. Clean the interior using a solution of bakingsoda and war water or water and mild soap Unit operates but does not The unit has just been started and it Typic...

Page 17 - SERVICE INFORMATION

17 SERVICE INFORMATION It is assumed that your combination beverage center/ice maker has been properly installed in accordance with allspecifications and local codes and the appliance has been properly grounded. If your unit should fail to operate, reviewthe troubleshooting chart before calling for ...

Page 19 - WARRANTY

UNDERCOUNTER/FREESTANDING COMBINATION BEVERAGE CENTER/ICE MAKER WARRANTY (Units certified for Indoor Use) T TW WO O Y YE EA AR R F FU ULLLL W WA AR RR RA AN NT TY Y Undercounter/freestanding combination beverage center/ice makers and all of their components and accessories, except as detailed below*...

Viking Combination Beverage Center - Manual

Table of Contents:

Summary

Other Viking Models