VEVOR QPJLS3MM000000001V1 - User Manual
VEVOR QPJLS3MM000000001V1 Food Slicer – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Advantages of the machine
The machine is characterized by the design of the cutter shaft as a
cantilever tupe ,which is installed at one end of the motor,transmission
parts and the cantilever cutter shaft,whlie the other end of the cutter
shaft,the other end of the shaft of the tool shaft,is on the outside of the
chassis,which is superior to the same product in the aspects of cleaning
and replacing the knife group.
Safety aspects
The magnetic control switich is connected in series with the motor
control loop,and is placed in the chassis,and the control magnet is installed
on the shield.When the shieid is lifted,the magnetic switich is in a state of
disconnection,and the motor can not rotate,thus ensuring personal safety.
(caution:never remove the safety shield operation).
Usage method
Connect the nominal voltage on the nameplate to the power supply with
the earth leakage protector,and the connectiong of the ground wire must be
good.The knife shaft closes the switch.Press the start button to obsereve
whether the steering of the knife group is correct,First cut into flaky,Recut
into filamentous,and then cut into granular,and can be replaced by a variety
of knife groups,to achieve slice,cut silk,chop,loose meat,tender meat and
other effects.
Cleaning method
Method1:rinse the blade from the entrance of the shield to the blade,or
remove the knife set and wash it with water.
Method 2:remove the knife set(without washing),and store it directly in the
freezer below 0 degrees,which is sanitary and convenient.
General troubleshooting
Oil tanks and gear bearings shall be lubricated regularly.Blunt blades
can be geinded with grinding wheels and oil stone stone strips.The motor
can not rotate—whether the shield is installed,whether the magnet is off, or
whether the magnet is covered with iron filings.
Use and maintenance
1. The motor must be reliabiy grounded.
2. When using the meat cutting machine,remove the steel comb above
and start the motor to see if the blade is tuining to the inside.
3. The meat left to be cut must be cleaned up to prevent blade damage.
4. After use.clean with hot water,start empty car,dry water,then add proper
amount of cooking oil to prevent rust.
Model
Shape
size(mm)
Voltage
Motor
power
Production
weig
ht
Packing
Size(mm)
HR -90 545*330*66
0
110V/60HZ
220V-240V/50HZ
750W
500kg/h
37kg 600*380*810
Note
；
The default size of knife set is 3mm,other size can be selected,110V /380V can
be customized.
Cut:pork,beef,sheep,chicken,jellyfish,and,othermeat,pickles,pickles,sa
uerkraut and other dishes.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
