Vanguard PM200 - Manual
Vanguard PM200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ii
- Page 3 – GENERAL INFORMATION; The POWERMAX; gas fired, infra-red water booster heater provides 180 degree; continues operating for a few minutes before going into a
- Page 4 – INSTALLATION CLEARANCES
- Page 5 – COMBUSTION AIR / VENTILATION; must be provided with an adequate supply of air for proper; EXHAUST VENTING
- Page 6 – above
- Page 7 – The snow level may be higher on walls exposed to prevailing winds.; Examples of ACCEPTABLE VENT PIPING/ See Appendix A; GAS PIPING; FLOWING; Incoming Line Pressure; Minimum Maximum; Manifold; TABLE 1
- Page 8 – tape on gas line threads. Use only
- Page 9 – WATER PIPING; Booster; Booster Heater to a cold water supply
- Page 11 – ELECTRICAL; DO NOT TURN THE POWER SWITCH ON UNTIL THE BOOSTER
- Page 14 – OPERATING SEQUENCE; Performance Data
- Page 15 – POWERMAX; For your safety, read completely before operating.; DO NOT turn Power Switch ‘on’ until the booster has been filled with
- Page 16 – PERSONAL INJURY OR DEATH.; surface
- Page 17 – TO TURN OFF GAS TO APPLIANCE; Turn off manual gas valve in gas supply piping.
- Page 18 – MAINTENANCE
- Page 19 – TROUBLE SHOOTING
- Page 23 – CLEARANCE TO COMBUSTIBLES; Flexible elbows parts # SVEFEX03 AND SVEFEX04
- Page 24 – Appendix A; SIDE WALL VENTING INSTALLATION; point of wall penetration where the minimum; JOINT PROCEDURE
- Page 25 – must not be penetrated; VERTICAL VENTING; HORIZONTAL VENTING; Refer to JOINT PROCEDURE before assembling system.
INSTALLATION & OPERATION MANUAL
DO NOT DISCARD THIS MANUAL!
P
OWER
M
AX
tm
GAS INFRA-RED WATER BOOSTER HEATERS
Model PM200 and PM400
IMPORTANT FOR YOUR SAFETY
WARNING:
IF THESE INSTRUCTIONS ARE NOT FOLLOWED EXACTLY, FIRE OR
EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY
OR DEATH.
-Do not store or use gasoline or any other flammable liquids or vapors in the vicinity of
this or any other appliance.
-WHAT TO DO IF YOU SMELL GAS
•
Do not try to light any appliance
•
Do not touch any electrical switch
•
Do not use any phone in the area
•
Immediately call your gas supplier from another location.
•
Follow gas suppliers instructions
•
If you cannot reach the gas supplier, call the local fire dept. or 911
-If overheating should occur or the automatic gas valve fails to operate properly, turn off
the manual gas valve on the gas supply piping to the appliance.
-Installation and service of this equipment must be performed by a qualified installer,
service agency or the gas supplier.
Tested to: ANSI Z21.10.3 1998
800-624-4809
CAN/CGA 1-4.3 M98
NSF Std. 5, 1992
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ii TABLE OF CONTENTS Page General Information 1 Installation Codes 2 Unpacking 2 Locating 2 Combustion Air/Ventilation 3 Exhaust Venting 3 Gas Piping 5 Water Requirements 6 Water Piping 7 Electrical 9 Wiring Diagrams 10 Operating Sequence 12 Start-up Procedure 13 Operating Instructions 14 To Turn Of...
1 GENERAL INFORMATION The POWERMAX tm gas fired, infra-red water booster heater provides 180 degree sanitizing rinse water for commercial dishwashing machines. Dishware and utensils used in the preparation and serving of food are required by Health Codes and the National Sanitation Foundation (NSF) ...
2 INSTALLATION CODES Installation must be performed in accordance with state and local codes, or, in the absence of local codes, with the following: National Fuel Code, ANSI Z223.1 (latest edition) the National Electric Code (NEC) ANSI/NFPA 70 (latest edition). Canada: CAN/CGA B149.1, CAN/CGA B149.2...
